VOLLRATH T39731A One Piece Cafeteria Breath Guard Installation Guide
- August 16, 2024
- VOLLRATH
Table of Contents
T39731A One Piece Cafeteria Breath Guard
Installation Instructions
One Piece Cafeteria Breath Guard
Three Piece Cafeteria Breath Guard
These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.
One Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath
guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the
plastic to crack.
1. Install the breath guard uprights (A) to the studs (B) securing with cap
nuts (C)
as shown. See Figure 1. Repeat for all four uprights.
Figure 1. One Piece Breath Guard Installation
2. Install the breath guard support tube (D) between the uprights (A)
securing with
cap nuts (C) as shown. Repeat on the other side.
3. Install the one piece breath guard (E) securing with screws (F) and cap
nuts (C)
as shown. Repeat for all four mounting locations.
4. Install the side breath protector (G) to the support tube (D) securing
with cap
nuts (C) as shown. Repeat on the other side.
Three Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath
guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the
plastic to crack.
1. Install the breath guard uprights (A) to the studs (B) securing with cap
nuts (C)
as shown. See Figures 1 and 2. Repeat for all four uprights.
Figure 2. Three Piece Breath Guard Installation
2. Install the breath guard support tube (D) between the uprights (A)
securing with
cap nuts (C) as shown. Repeat on the other side.
3. Install the side breath guards (E) securing with screws (F) and cap nuts
(C) as
shown. Repeat for all mounting locations.
4. Install the side shield (G) to the support tube (D) securing with cap nuts
(C) as
shown. Repeat on the other side.
5. Install the support bar and stud assembly (H) to the side breath guards
(E).
Repeat for all mounting locations.
6. Install the top breath guard (I) to the support bar and stud assembly (H)
securing with cap nuts (C). Repeat for all mounting locations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>