FUNPOWER FT0317YG Remote Control Transmitter Instruction Manual

: August 8, 2024
: Funpower

FUNPOWER FT0317YG Remote Control Transmitter

INSTRUCTION MANUAL

I. Operation Instructions

1. OFF the Fan

When fan are on, press this button, the fan shut down.

2. Breeze Mode: Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. Reach one specific speed, it changes to another speed.

3. Speed of the fan (1~6 level)

The “+” key increases the fan gear. The higher the gear, the higher the fan speed.
The “-” key lowers the fan gear, and the lower the gear, the lower the fan speed.
The number of indicators displayed corresponds to the current fan gear.
The lowest gear is 1st gear and the highest gear is 6th gear.

4. Fan timing control

Set up the timer at 2hours,4hours ,8 hours.
2H press this key, the fan will stop after 2 hours.
4H press this key, the fan will stop after 4 hours.
8H press this key, the fan will stop after 8 hours.

The timing function of the key works when the fan is running.
Press the key “+”or”-” will cancel the timer.
The latest timer will take place the previous one.
The number of LED lights corresponds to the number of hours when the fan is shut down.

5. Direction of the fan

Press the key to control the direction of the fan fan to make the wind blow on the ground or blows upward from the ceiling.. It is usually used in summer.

6. ON/OFF the light

Press the key to control the light ON/OFF.

7. Brightness adjustment

Press the key to adjust light intensity.

8. ID switch

Switch between Public and private codes.

9. Learn key

Transmitter and receiver matching learning.

8. The transmitter use 2pcs of 1.5V AAA battery, please install the battery correctly.

II. Use precautions

1. When press the key of transmitter, the LED indicator doesn’t on, please inspect the battery installation.
2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one.
3. Please pull out of the battery from the transmitter when leaving unused for a long time.

FCC Instructions：

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the product and receiver.
Connect the product into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause Undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

FCC ID: 2ABUP-FT0317YG

IC Caution:

RSS-Gen Issue 5 “&” RSS-Gen numéro 5

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF exposure statement:

The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment.

Specifications:

Model: FT0317YG Remote Control Transmitter
Power Source: 2 x 1.5V AAA batteries
LED Indicator: Indicates fan and light status
Control Functions: Fan speed, timer, fan direction, breeze mode, light on/off, brightness adjustment
Special Feature: Learn key for transmitter and receiver matching

Product Usage Instructions:

1. Turning Off the Fan:

Press the “OFF” button when the fan is on to shut it down.

2. Breeze Mode:

Between Speed 2 to Speed 4, the fan will change speeds in a curve and circle motion after 40 seconds.

3. Fan Speed Adjustment:

Use the “+” key to increase fan speed and the “-” key to decrease it. There are 6 levels of speed indicated by LED lights.

4. Fan Timer Control:

Set the timer for 2, 4, or 8 hours. Press the corresponding key to stop the fan after the set time.

5. Fan Direction Control:

Change the direction of the fan to blow air downwards or upwards using the designated key.

6. Light Control:

Turn the light on/off with the dedicated key.

7. Brightness Adjustment:

Adjust the light intensity using the brightness adjustment key.

8. ID Switch:

Switch between Public and Private codes with the ID switch.

9. Learn Key:

Use the Learn key for transmitter and receiver matching learning.

10. Battery Installation:

Insert 2 AAA 1.5V batteries into the transmitter correctly.

Use Precautions:

If the LED indicator doesn’t turn on when pressing a key, check battery installation.
If the LED indicator flashes when pressing a key, replace the batteries with new ones.
Remove batteries from the transmitter if it will be unused for an extended period.