FUNPOWER FT0309HDAM Remote Control Transmitter User Manual

FUNPOWER FT0309HDAM Remote Control Transmitter

Product Information

Specifications

• Model: FT0309HDAM
• Power Source: 2 x 1.5V AAA batteries
• Control: Remote Control Transmitter
• Features: LED Indicator, Breeze Mode, Fan Speed Control, Timer, Direction Control

Product Usage Instructions

1.  ON/OFF the Fan
   Press this button to turn the fan on or off. When the fan is off, pressing this button will resume the fan at the previous speed.

2. Breeze Mode
   Between Speed 2 to Speed 4, the fan will operate in a curve and circle speed pattern. It will change speeds at specific intervals.

3. Speed of the Fan
   Use the + key to increase the fan speed (1 to 9 levels) and the – key to decrease it. The number of LED indicators corresponds to the current fan speed level.

4. Fan Timing Control
   Set the timer for 2 hours, 4 hours, or 6 hours. Press the corresponding key to stop the fan after the specified time. Pressing + or – will cancel the timer.

5. Direction of the Fan
   Press the direction keys to control whether the fan blows air towards the ground or upward from the ceiling. Hold for 5 seconds to activate this function.

6. ID Switch
   Switch between Public and private codes for control.

7. Learn Key
   Used for transmitter and receiver matching learning.

8. Battery Installation

The transmitter uses 2 x 1.5V AAA batteries. Ensure correct installation of the batteries.

Use Precautions

1. If LED indicator doesn’t turn on when pressing transmitter key, check battery installation.
2. If LED indicator flashes when pressing transmitter key, replace batteries with new ones.
3. Remove batteries from the transmitter when not in use for an extended period.

FCC Instructions

• Reorient or relocate the receiving antenna if needed.
• Increase separation between product and receiver if interference occurs.
• Connect product to an outlet on a different circuit than the receiver.
• Consult dealer or technician for assistance if necessary.
• This device complies with Part 15 of FCC Rules.
• Warning: Unauthorized changes may void user’s authority to operate the product.

FAQ

• Q: How can I change the battery in the transmitter?
  A: To change batteries in the transmitter, open the battery compartment, remove old batteries, and insert new 1.5V AAA batteries in the correct orientation.

• Q: How do I know if the timer is set correctly?
  A: The number of LED lights displayed corresponds to the number of hours set for the timer. Ensure the desired hours are illuminated before confirming the timer setting.

USER MANUAL FOR FT0309HDAM REMOTE CONTROL TRANSMITTER

Operation Instructions

1. ON/OFF the Fan
   • When fan shut down, press this button, the fan run at the speed before fan shutdown.
   • When fan are on, press this button, the fan shut down.
2. Breeze Mode: Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. Reach one specific speed, it changes to another speed.
3. Speed of the fan (1~9 level)
   • The “+” key increases the fan gear. The higher the gear, the higher the fan speed.
   • The “-” key lowers the fan gear, and the lower the gear, the lower the fan speed.
   • The number of indicators displayed corresponds to the current fan gear.
   • The lowest gear is 1st gear and the highest gear is 9th gear.
4. Fan timing control Set up the timer at 2hours,4hours ,6 hours.
   • 2H press this key, the fan will stop after 2 hours.
   • 4H press this key, the fan will stop after 4 hours.
   • 6H press this key, the fan will stop after 6 hours.
   • The timing function of the key works when the fan is running.
   • Press the key “+”or”-” will cancel the timer.
   • The latest timer will take place the previous one.
   • The number of LED lights corresponds to the number of hours when the fan is shut down.
5.  Direction of the fan
   • Press the key to control the direction of the fan fan to make the wind blow on the ground. It is usually used in summer.Press and hold this key for 5 seconds to turn on this function. At the same time, the LED lights will display from bottom to top in order. Finally, all the indicators will turn on and off.
   •  Press the key to control the direction of the fan, so that the wind blows upward from the ceiling. It is usually used in winter.Press and hold this key for 5 seconds to turn on this function. At the same time, the LED lights will be displayed in order from top to bottom. Finally, all the indicators will turn on and off.
6. ID switch
   • Switch between Public and private codes.
7. Learn key
   • Transmitter and receiver matching learning.
8. The transmitter use 2pcs of 1.5V AAA battery, please install the battery correctly.

Use precautions

1. When press the key of transmitter, the LED indicator doesn’t on, please inspect the battery installation.
2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one.
3. Please pull out of the battery from the transmitter when leaving unused for a long time.

FCC Instructions：

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause Undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

IC Caution:

RSS-Gen Issue 5 “&” RSS-Gen numéro 5
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment.

IC：25540-FT0309HDAM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>