FUNPOWER FT1209R Remote Control Transmitter User Manual
- June 1, 2024
- Funpower
Table of Contents
FUNPOWER FT1209R Remote Control Transmitter
Product Information
- Specifications:
- Model: FT1209R Remote Control Transmitter
- FCC ID: 2ABUP-FT1209R
- IC Caution: IC25540-FT1209R
FAQs
- Q: What should I do if the LED indicator doesn’t turn on when pressing a key?
- A: Check the battery installation to ensure proper connection.
- Q: How do I know when to replace the battery?
- A: The LED indicator flashing indicates low battery voltage, prompting you to replace it with a new one.
- Q: Should I remove the battery when not using the transmitter for a long time?
- A: Yes, it is recommended to remove the battery if the transmitter is unused for an extended period to prevent any potential issues.
Operation Instructions
- OLED Indicator
- Fan ON/OFF(Pairing Button)
- Fan Forward/Reverse
- Fan Speed Down
- Fan Speed Up
- Timer Control and Indicator
- Natural Wind
- ATTERY:12V/23Ax1
Use precautions
- When press the key of the transmitter, the LED indicator doesn’t on, please inspect the battery installation.
- When pressing the key of the transmitter, the LED indicator flashes, which means the battery gets low voltage, please replace a new one.
- Please pull out the battery from the transmitter when left unused for a long time.
FCC
FCC Instructions
This product has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and the receiver.
- Connect the product to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device m not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate the product. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
- FCC ID: 2ABUP-FT1209R
IC Caution:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
RF exposure statement:
- The equipment complies with the IC Radiation exposure limit set forth for uncontrolled environments.
- The device has been evaluated to meet general RF exposure requirements.
- The devicecan be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>