Shenzhen Funpower General Technology FT12W09 In Wall Transmitter User Manual

June 6, 2024
Shenzhen Funpower General Technology

Fun power General Technology FT12W09 In-Wall Transmitter
User Manual

Operation Instructions

FT12W09 in-wall transmitter

  1. Main power switch:
    True on/turn off the wall controller power supply, push the switch button to “on”, then the wall controller and ceiling controller can work.

  2. Fan off:
    • When operating, press the key to stop the fan.
    • This key is for the fan off only.

  3. Speed of the fan (1~6 level):
    • Press the key ”1,2,3,4,5,6” to adjust the fan to the designated speed level.
    • After pressing speed level Keys, the fan will enter the corresponding speed level from another speed levels or idle.
    • Key “1” is the lowest speed, and key”6 “is the highest speed.

  4. “ REV ” Direction of the fan
    • Press the key REV can change the running direction of the fan.

  5. “O D “ Dimmer function enabled switch:
    Release the screw then remove the top panel, push the switch to “o” can shut down the light adjust feature.
    The light button can turn on and turn off the light only. When pushing the switch to “D” can open the light adjust feature, short press the light button to turn on and turn off the light, and long-press the light button for brightness adjustment. (Remark: the controller and the light should support brightness adjustment)

  6. “LIGHT” Lighting control:
    • LIGHT Light on or off.
    • Long press for brightness adjustment (Initiate the brightness adjustment and the controller and the light should support brightness adjustment)

Use precautions

  1. Wall controller used with ceiling fan controller only and connect in series on AC L wire of ceiling controller.
  2. Please check the switch status if the indicator does not flash when pressing the key.
  3. The person qualified for maintenance only.
  4. A ground connection well is necessary for installation.

FCC Instructions:
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the product and receiver.
  • Connect the product into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

IC Notice:
In addition to containing other required statements specified elsewhere in this standard or in the applicable RSS, user manuals for license-exempt radio apparatus shall contain  the following text, or an equivalent notice, that shall be displayed in a conspicuous location, either in the user manual or on the device, or both:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is  subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals