aidapt VR270B Urine Catheter Bag Holders Instruction Manual
- June 3, 2024
- Aidapt
Table of Contents
aidapt VR270B Urine Catheter Bag Holders
Usage and Maintenance Instructions
INTRODUCTION
Thank you for deciding to purchase the Urine/Catheter Bag Holder from Aidapt.
BEFORE USE
- Carefully remove all packaging. Avoid using any knives or other sharp instruments as this may damage the surface of the product.
- Check the product for any visible damage If you see any damage or suspect a fault, do not use your product as it may compromise your safety, but contact your supplier for support.
USING YOUR URINE/CATHETER BAG HOLDER
These Urine or Catheter Bag Holders will accept all popular bags and include hooks on which to hang the bag (from the hanging holes at either corner)they also feature an integrated clip to hold the inlet tube.
- VM270A is designed to rest on the floor, but can also be used as a hanging holder from the edge of the bed or bed rail.
- VM270B is designed as a hanging holder from the edge of the bed or bed rail only.
- VM270C is designed as a hanging holder to be slotted over the edge of the bed or bed rail.
CLEANING
Our equipment can be cleaned and or disinfected as per MHRA guidance on
decontamination MHRA DB 2003 (06)
Do not use abrasive cleaners as this could damage the surface of the
equipment. For cleaning, wipe with a clean cloth soaked in detergent solution
and wring out. Depending on the detergent manufacturer’s instructions the
solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed
periodically and the detergent changed frequently. The detergent should be
rinsed or wiped off using a clean cloth immersed in clean water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe
over with a clean cloth and a compatible liquid disinfectant. After
disinfecting clean with clean water and dry.
When using detergent or disinfectants then please refer to manufacturers’
instructions and if unsure then consult your local Infection Control
Specialist for advice.
When using moist heat the equipment can be held at 81º C for at least a minute
to achieve disinfection.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check
all components for their safety.
If in any doubt, please do not issue or use, but immediately contact your
supplier for service support.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming
part of or establishing any contractual or other commitment by Aidapt
Bathrooms Limited, Aidapt (Wales) Ltd or its agents or its subsidiaries and no
warranty or representation concerning the information is given.
Please exercise common sense and do not take any unnecessary risks when using
this product; as the user you must accept liability for safety when using the
product.
Please do not hesitate to contact the person who issued this product to you or
the manufacturer (detailed below) if you have any queries concerning the
assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX
Telephone: +44 (0) 1744 745 020
• Fax: +44 (0) 1744 745 001
• Web: www.aidapt.co.uk
Email: accounts@aidapt.co.uk
• adaptations@aidapt.co.uk
• sales@aidapt.co.uk