hidealite Moon Slim IP44 2300lm Instructions
- June 3, 2024
- hidealite
Table of Contents
hidealite Moon Slim IP44 2300lm
For explanation of symbols see www.hidealite.se
E-nr | Snro | El.nr | GTIN | Name | LED Color | Total Effect |
---|---|---|---|---|---|---|
7508331 | 4143800 | 3207097 | 7392971145327 | Moon Slim SC 320 | 3000K;4000K | 18W |
7508332 | 4143801 | 3207098 | 7392971145334 | Moon Slim SC 380 | 3000K;4000K | 23W |
7508552 | 4143827 | 3207111 | 7392971145570 | Moon Slim SC EM 320* | 3000K;4000K |
21W
7508553| 4143828| 3207113| 7392971145587| Moon Slim SC EM 380*| 3000K;4000K|
26W
This product contains a light source of energy efficiency class D to Regulation (EU) No 2019/2015.
Accessories
Accessories for Moon Slim SC 320 & 380
E-nr | Snro | El.nr | GTIN | Name |
---|---|---|---|---|
7508558 | 4143833 | 3207135 | 7392971145631 | Moon Slim Emergency light module |
7508559 | 7112601 | 3207136 | 7392971145648 | Moon Slim Emergency light battery |
SAFETY INSTRUCTIONS
Read these instructions carefully before commencing installation and retain for future reference. The luminaire should be installed by a licensed electrician and in accordance with local regulations. Make sure that the power is off before installation or maintenance.
Installation
NOTE! Only change when fixture is OFF
Make sure that L and N are correctly connected, otherwise the sensor will break
Range – Ceiling mounting pattern (Unit: m)
Highest mounting height is 4m
Detection area – Detection area can be reduced by selecting the combination on the DIP switches to fit precisely each application .
Hold Time – Refers to the time period the lamp remains at 100% illumination after no motion detected.
Daylight sensor – The sensor can be set to only allow the lamp to
illuminate below a defined ambient brightness threshold.
When set to Disable mode, the daylight sensor will switch on the lamp when
motion is detected regardless of ambient light level.
50lux: twilight operation, 10lux, 2lux: darkness operation only. Note
that daylight sensor is active only when lamp totally switches off.
Stand-by period – Refers to the time period the lamp remains at a low light level before it completely switches off in the long absence of people. When set to “+ ” mode, the low light is maintained until motion is detected.
Stand-by dimming level – The low light level you would like to have after the hold time in the long absence of people.
With insufficient ambient light, the sensor switches on the lamp when motion is detected.
DIAGRAM
HN263-SC
Operating voltage| 220-240VAC, 50Hz/60Hz
Switching capacity| Max 400W
Stand-by power| <1W
Detection area| 10% / 50% / 75% / 100%
Hold time| 5s/30s/1min/5min/10min/20min/30min
Daylight threshold| 2Lux/10Lux/50Lux/Disable
Microwave frequency| 5,8GHz ± 75MHz
Microwave power| <0,3mW
Mounting height| Max.4m (ceiling mounted)
Detection range| Max.Ø12m (ceiling mounted)
Motion detection| 0,5~1,5m/s
Case temperature (Max.)| Tc: +70°C
Operating temperature| -25°C ~ +60°C
IP rating| IP20
Installation Moon Slim SC EM 320 & 380 and 320 & 380 with EM accessories
NOTE! Only change when fixture is OFF
Suggestion
NOTE! Installation example, the emergency light module requires connection to neutral and constant current.
Connect battery
When voltage is applied – the emergency light module starts self-test.
Flashing green light:
Battery is charging/normal operation
Permanent green light:
Battery fully charged/normal operation
Emergency light module performs automatic self-test every 30 and 180 days.
Manual self test:
- Press and hold the test button for 1-5sec.
- LED of the emergency light module lights up.
Every 30 days – automatic self-test
Every 180 days – The LED of the emergency light module lights up for 1,5 hours for a complete battery and module test.
Troubleshooting
Flashing red light
- Check the connection cable between the battery and the module.
- Press and hold the test button for 10sec.
- The emergency light module resets and starts self-test.
Flashing / Permanent green:
Normal operation on module and battery
Flashing red light:
Battery not connected/Battery defective.
Replace battery – Press and hold the test button for 10sec.
Solid red light:
Defective emergency light module
Replace emergency light module and battery
Replaceable (LED only) light source by a professional
Replaceable control gear by a professional
Elektro Elco AB, Tallvägen 5, SE-56435 Bankeryd, Sweden
info@elco.se
www.hidealite.se
www.hidealite.uk
www.hidealite.fi
www.hidealite.no
www.hidealite.dk
References
- Vi udvikler og sælger LED belysning - Hidealite
- LED-valaisimet & LED-valaistus kotiin ja julkisiin tiloihin - Hide-a-lite
- LED-belysning, downlights, spotlights och utendørs belysning av topp kvalitet - Hidealite
- Hide-a-lite - LED-belysning & LED-armaturer för ditt projekt! - Hide-a-lite
- LED lighting of the highest quality - Hidealite
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>