GERMAN POOL MIF-150 Electric Milk Frother User Manual

GERMAN POOL MIF-150 Electric Milk Frother

Please register your warranty information now! For Warranty Terms & Conditions,  please refer to the last page of this user manual.

Notice Before Use

Important For safety purpose, please observe the following safety precautions to avoid injury or property damage. Failure to follow the safety warning may result in an accident.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised.
• Keep the appliance and its cord out of reach of children aged less than 8 years.
• Make sure your electricity supply matches the voltage shown on the appliance.
• Ensure all packaging materials and any promotional labels or stickers are removed from the appliance before the first use.
• Always inspect the appliance before use for noticeable signs of damage. Do not use if damaged or has been dropped. In the event of damage, or if the appliance develops a fault contact the customer service and repair centre.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Always use the appliance on a dry, level, heat resistant surface.
• Unplug from the mains when not in use and before cleaning. To disconnect, turn the socket to “off “and remove the plug from the mains socket.
• Do not use any accessories or attachments with this appliance other than those recommended by manufacturer.
• To protect against fire, electric shock or personal injury, do not immerse cord, plug or lid in water or other liquids.
• Do not leave the lead hanging over the edge of a kitchen table or worktop. Avoid contact between the lead and hot surfaces.
• For indoor use only.
• For domestic use only.
• This appliance should be used for preparation of drinks as described within the instructions for use that accompany it.
• Always ensure that your hands are dry before removing the plug from the mains socket. Never pull the plug out of the mains socket by its lead.
• To avoid injury or possible fire, do not cover the appliance when in use.
• Do not connect this appliance to an external timer or remote control system.
• An extension cable may be used with care. The electrical rating of the cable should be at least as great as the appliance. Do not allow the cable to hang over the edge of the worktop or touch any hot surfaces.
• This appliance complies with the basic requirements of Directives 2014/30/EU and 2014/35/EU.
• WARNING : A cut off plug inserted into a 13amp socket is a serious safety (shock) hazard. Ensure the cut off plug is disposed of safely.
• CAUTION : The plastic bags used to wrap this appliance or the packaging may be dangerous. To avoid risk of suffocation, keep these bags out of reach of babies and children. These bags are not toys.
• Keep the Milk Frother, including its plug and lead away from hot ovens, electric and gas burners, flames and hot surfaces.
• Do not touch any moving parts whilst in use. Always switch off the appliance and wait until the whisk has stopped rotating before you open the lid.
• Surfaces may be hot when the Milk Frother is in use or just used. Use the handle and take care when removing the lid.
• Milk will remain hot for a considerable time after heating and is a scalding hazard.
• Ensure the lid is fully closed before switching on. Do not open the lid when milk is heating, scalding may occur if the lid is lifted.
• Ensure the Milk Frother is securely on the base before switching on. The Milk Frother must be only used with the base supplied by the manufacturer. Do not use the base with any other appliances.
• Keep hands away from the spout when milk is heating, steam is hot.
• The Milk Frother must be filled to at least the ‘MIN’ mark inside before it is switched on. Do not fill beyond the ‘MAX MILK’ or ‘MAX FROTH’ level.
• Do not lift or move the Milk Frother while in use.
• Remove the Milk Frother from the base to fill or pour. Pour slowly and do not over-tilt the Milk Frother.
• Do not leave the Milk Frother unattended while it is frothing milk.
• Do not use metal spoons or other utensils with sharp edges to spoon milk or froth from the appliance. These will scratch the coating inside. Pour only.
• Only heat milk in the Milk Frother, do not heat any other liquids, apart from the first use.
• Do not operate empty.
• The instructions for appliances normally cleaned after use and not intended to be immersed in water for cleaning, state that the appliance must not be immersed. See more details about cleaning in “cleaning and maintenance”.

Product Structure

Operating Instructions

ASSEMBLE
WARNING : Do not insert the plug into an electrical outlet, or turn on the Milk Frother before you have fully assembled it.

1. Unpack the Milk Frother, remove all the packaging materials.
2. Before first use, wipe the jug with a clean damp cloth.
3. Wash the lid, whisk and whisk holder in warm soapy water, rinse and dry.
4. Insert the whisk holder and whisk inside the jug. The whisk magnet will click into place on the inside.
5. Place the jug on the base unit. Fill it with tap water to the ‘MAX FROTH’ level inside the jug.
6. Cover the lid, plug in and switch on at the socket.
7. Press the on/off button once. The button will illuminate red, and the whisk will start to rotate.
8. The light will go out and the whisk will automatically stop when the water is warm.
9. Discard the warm water, the machine is now ready to use.

WARM MILK FROTH
Froth 150ml of hot milk in 2 – 2.5 minutes

1. Put the whisk into the whisk holder.
2. Fill milk and press the On/Off button to switch on the appliance.
3. The On/Off button lights up in red. This is the setting for the warm milk froth.
4. The appliance starts to make milk froth and stops automatically as soon as the process is finished.

NOTE : Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX FROTH marking. Otherwise milk and froth will burn dry or overflow.

COLD MILK FROTH (Room Temperature)
Froth 150ml of cold milk (Room Temperature)

1. Put the whisk into the whisk holder.
2. Fill milk and press the On/Off button for approximately 2-3 seconds until it lights up in blue.
3. The appliance starts to make milk froth and stops automatically as soon as the process is finished.
   NOTE : Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX FROTH marking. Otherwise the motor will burn dry or overflow.

WARM MILK
Heat 250ml of hot milk

1. Put the whisk into the whisk holder.
2. Fill milk and press the On/Off button twice. The button will light up and blink in red. This is the setting for milk-warming.
3. The whisk rotates with reduced speed in order to ensure even heat distribution and prevent the milk from burning.

NOTE : Make sure the Milk Frother is filled to at least the MIN mark and not exceed the MAX MILK marking. Otherwise the motor will burn dry or overflow.

SETTINGS

WARNING

• Ensure the lid is fully closed before switching on. Do not open the lid when milk is heating, scalding may occur if the lid is lifted.
• Do not touch any moving parts whilst in use. Always switch off the appliance and wait until the whisk has stopped rotating before you open the lid.
• Remove the Milk Frother from the base to fill or pour. Pour slowly and do not over-tilt the Milk Frother.

A GUIDE TO INGREDIENTS
Different milks, for example UHT long life, fresh semi-skimmed milk and whole milk will all froth to different levels so you may need to reduce the amount of milk you use.

• Semi-skimmed milk often gives the best results for frothing.
• Add your other ingredients (for example, coffee, drinking chocolate, sugar) to your mug and pour the warmed milk on top of them. Do not put the additions into the Milk Frother as the sugars may cause it to overheat.

USER TIPS

• Only heat milk in the Milk Frother. Do not put other ingredients, such as drinking chocolate, coffee or sugar into the Milk Frother.
• Certain types of milk, for example long life, can froth more than others, so your milk may leak out – reduce the amount of this kind of milk.
• Rinse the jug as soon as you have finished using it and it will be easier to clean.

Care & Maintenance

NOTE:

• Before cleaning, please make sure the power plug is pulled out. Cleaning shall not be taken unless the body cools down.
• Before first use and after every use, clean each part thoroughly.
• Periodically check all parts before reassembly.
• Never immerse the jug or base in water or any other liquids.
• Do not use abrasive cleaners, bleaching agents or metal scourers on any parts. This will damage the appliance.
• Do not put any parts of the milk frother in the dishwasher.
• Do not use metal spoons or other utensils with sharp edges to spoon milk or froth from the appliance. These will scratch the coating inside. Pour only.
• Store the milk frother with the power cable loosely coiled. Never wrap it tightly around the machine.

To clean the surface of the jug and the base, wipe with a clean, damp cloth and dry before storing. Rinse the inside of the jug with hot soapy water, rinse with clean water and dry thoroughly. Do not use hard or sharp objects to clean inside the jug, this will damage the non-stick coating.

To clean the whisk and holder, push the whisk out of the holder. Clean the lid, whisk and holder with warm soapy water and a soft sponge or cloth. Rinse and dry thoroughly. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Troubleshooting

If the following problems are encountered, follow the instructions below. If the problem persists, please contact our customer service and repair centre.

into jug.

| Make sure milk in the jug is

below the maximum fill lines.

The jug will not switch on.

|

The jug may not be placed properly on the base.

| Check the jug is placed correctly on the base and check power is

on at the socket.

Technical Specifications

Specifications are subject to change without prior notice. If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail. Refer to www.germanpool.com for the most up-to-date version of the user manual.

Customer Service & Repair Centre
10/F, Kowloon Godown
1-3 Kai Hing Road, Kowloon Bay,
Kowloon, Hong Kong
Tel: +852 2333 6249
Fax: +852 2356 9798
Email:repairs@germanpool.com

References

• 德國寶German Pool | 家庭電器、廚櫃、傢俬 | 香港十大名牌

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>