YITA Motor C-3037 6 Inches Running Boards Installation Guide
- August 2, 2024
- YITA Motor
Table of Contents
YITA Motor C-3037 6 Inches Running Boards
Tools Required
- 13mm Socket
- Ratchet
- Torque Wrench
Notes
- Read this instruction carefully before starting installation.
- Verify all parts especially the direction of the step bar and brackets before installation.
- If missing parts or any damage is found, please take a picture and contact us.
INSTALLATION INSTRUCTION
Step 1:
- Locate three mounting positions on each side.
- Remove plastic plugs or hex bolts from the factory mounting positions.
- Clean the sealant and dirt around factory threaded holes on mounting positions.
Step 2:
- Attach the bracket to the rocker panel and secure it with (2) M8 hex bolts.
- Repeat to install all brackets. Do not fully tighten.
Step 3:
- Remove (6) M8 hex bolts and (6) M8 flat washers under the step bar.
- Slide mounting tracks to proper positions.
- With assistance, lift and attach the step bar to brackets.
- Secure the step bar on brackets with (6) M8 hex bolts and (6) M8 flat washers.
- Repeat to install the other side step bar. Do not fully tighten.
Step 4:
- Tighten M8 hex bolts on the vehicle with 15 ft. Ibs. torque.
- Adjust the step bar to level and tighten M8 hex bolts on the step bar with 15 ft. Ibs. torque.
- After the step bar is installed, periodic check to ensure all mounting hardware remains secure and tight.
Part List
Read User Manual Online (PDF format)
Loading......