YITA Motor C- 3023 Crew Cab Running Boards Instruction Manual

YITA Motor C- 3023 Crew Cab Running Boards

Tools Required

• 13mm Socket
• Ratchet
• Torque Wrench

Notes

• Read this instruction carefully before starting installation.
• 09-12 models require self-drilling on pinch weld to install brackets.
• Proper tools will improve the quality of installation and reduce the time required.
• If missing parts or any damage is found, please take a picture, and contact us.

INSTALLATION STEPS

• Step 1:

1. Locate three mounting positions on each side.
2. Remove the factory tape and clean the sealant and dirt around the factory holes on mounting positions.
3. Clean the factory threaded holes if equipped.

• Step 2A:
  • For models w/o factory threaded inserts
  1. Insert the (2) M8 bolt plates into factory hexagon holes. Flat plate side in, thread side out.
  2. Attach the bracket to the threaded end of the bolt plate and secure it with (2) M8 flat washers and (2) M8 hex nuts.
  3. Secure the bracket to pinch weld with (2) M8 hex bolts, (2) M8 flat washers, and (2) M8 hex nuts.
  • Note: 09-12 models require self-drilling on pinch weld.
• Step 2B:
  • For models with factory-threaded inserts
  1. Attach the bracket to the inner rocker panel and secure it with (2) M8 hex bolts, and (2) M8 flat washers.
  2. Secure the bracket to pinch weld with (2) M8 bolt plates, (2) M8 flat washers, and (2) M8 hex nuts.
• Step 3:

1. Remove (6) M8 hex bolts and (6) M8 flat washers behind the step bar.
2. Slide mounting track to proper positions.
3. With assistance, lift and attach the step bar to brackets. Secure the step bar on brackets with (6) M8 hex bolts and (6) M8 flat washers.
4. Repeat to install the other side step bar, do not fully tighten.![YITA-Motor-C-3023-Crew-Cab-Running-Boards-FIG-1 \(3\)](https://manuals.plus/wp-content/uploads/2024/04/YITA-Motor-C-3023-Crew-Cab-Running-Boards-FIG-1-3.png)

• Step 4:

1. Tighten M8 hex bolts and nuts on a vehicle with 15 ft. Ibs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. Ibs. torque.
3. After the step bar is installed, periodic check to ensure all mounting hardware remains secure and tight.![YITA-Motor-C-3023-Crew-Cab-Running-Boards-FIG-1 \(4\)](https://manuals.plus/wp-content/uploads/2024/04/YITA-Motor-C-3023-Crew-Cab-Running-Boards-FIG-1-4.png)

Part List

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>