YITA Motor CEETSS-1008-1 Drop Side Steps Instruction Manual
- June 15, 2024
- YITA Motor
Table of Contents
CARE AND USE INSTRUCTIONS
ceetss-1008
CEETSS-1008-1 Drop Side Steps
Tools Required
13mm Socket
Ratchet
Torque Wrench
Notes
Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time
required.
Remove the paint buildup on the factory threaded studs.
If missing parts or any damage found, please take a picture and contact us.
Professional installation would be highly recommended.
Step 1:
- Locate (3) mounting positions each side.
- Clean factory painting on mounting studs before installation.
- Clean the sealant and dirt around mounting positions.
Step 1:
- Attach the bracket to the factory studs on inner rocker panel.
- Secure the bracket to inner rocker panel with (3) M8 flat washers, (3) M8 lock washers, (3) M8 hex nuts.
Step 3
- With assistance, lift and attach the step bar to the brackets.
- Secure (3) support brackets and step bar onto brackets with (9) M8 flat washers, (9) M8 lock washers, (9) M8 X 30 hex bolts.
Step 4
- Tighten M8 hex nuts on vehicle with 15 ft. Ibs. torque.
- Adjust the step bar to level and tighten M8 hex bolts with 15 ft. Ibs. torque.
- After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.
Part List
| 1 | Qty. Description |
|---|---|
| 2 | X 18 M8X 30 Hexagon Bolt |
| 3 | X36 M8 Flat Washer |
| 4 | X36 M8 Lock Washer |
| 5 | M8 Hexagon Nut |
| 6 | X6 Mounting Bracket |
| 7 | X6 Support Bracket |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>