YITA Motor CEETSS-1003-1 Drop Side Steps Compatible Instruction Manual

**YITA Motor CEETSS-1003-1 Drop Side Steps Compatible Instruction Manual

**

CARE AND USE INSTRUCTIONS

NOTE

Read this instruction carefully before starting installation. Proper tools will improve the quality of installation and reduce the time required.
If missing parts or any damage found, please take a picture, and contact us. Professional installation would be highly recommended.

Step 1:

1. Locate (3) mounting positions on each side inner rocker panel.
2. There are 4 mounting positions each side, we will use the 1st, 2nd, 4th. Step 3
3. Clean the sealant and dirt around mounting positions.
4. Remove rubber plugs and clean factory threaded inserts.

Step 2:

1. Attach the bracket to the thread inserts on inner rocker panel.
2. Secure the bracket to inner rocker panel with (2) M8X25 hex bolts, (2) M8 lock washers, (2) M8 flat washers.
   Note: The passenger side is shown, repeat on the driver side.

Step 3:

1. With assistance, lift and attach the step bar to the brackets.
2.  Secure (3) support brackets and step bar onto brackets with (9) M8 flat washers, (9) M8 lock washers, (9) M8 X 30 hex bolts.
   
   

Step 4:

1. Tighten M8 hex bolts on vehicle with 15 ft. Ibs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. Ibs. torque.
3. After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.

Part List:

| Qty.| Description
---|---|---
0 ® ® ® ® ©| x 12 x18 X 30 X 30 x6 x6| M8 x 25 Hexagon Bolt
M8 x 30 Hexagon Bolt
M8 Flat Washer
M8 Lock Washer
Mounting Bracket
Support Bracket

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>