YITA Motor CEETSS-1005 Drop Side Steps Instruction Manual
- June 2, 2024
- YITA Motor
Table of Contents
YITA Motor CEETSS-1005 Drop Side Steps
Tools Required
- 13mm Socket
- Ratchet
- Torque Wrench
Notes
- Read this instruction carefully before starting installation.
- Proper tools will improve the quality of installation and reduce the time required.
- If missing parts or any damage is found, please take a picture, and contact us. Professional installation would be highly recommended.
INSTALLATION
Step 1:
- Locate (3) mounting positions on each side inner rocker panel.
- There are 4 mounting positions on each side, we will use the 1st, 2nd, and 4th.
- Clean the sealant and dirt around mounting positions.
- Remove rubber plugs and clean factory threaded inserts.
Step 2:
- Attach the bracket to the thread inserts on the inner rocker panel.
- Secure the bracket to the inner rocker panel with (2) MSX25 hex bolts, (2) MS lock washers, and (2) MS flat washers.
Note : The passenger side is shown, repeat on the driver side.
Step 3:
- With assistance, lift and attach the step bar to the brackets.
- Secure (3) support brackets and step bar onto brackets with (9) MS flat washers, (9) MS lock washers, and (9) MS x 30 hex bolts.
Step 4:
- Tighten M8 hex bolts on a vehicle with 15 ft. lbs. torque.
- Adjust the step bar to level and tighten M8 hex bolts with 15 ft. lbs. torque.
- After the step bar is installed, periodic check to ensure all mounting hardware remains secure and tight.
Part List
Read User Manual Online (PDF format)
Loading......