LASKO 1129 Gallon Recirculating Humidifier Instruction Manual

: July 31, 2024
: Lasko

Table of Contents

1129 Gallon Recirculating Humidifier
Product Information
Specifications:
- Product Usage Instructions
Filling:
Operation:
- FAQ:
Troubleshooting:

1129 Gallon Recirculating Humidifier

“`html

Product Information

Specifications:

Model: LASKO 1129
Water Capacity: 4.5 Gallons
Jug Capacity: 1-1/2 Gallons
Base Capacity: 3 Gallons

Product Usage Instructions

Filling:

CAUTION: Do not pour water through the Exhaust
Grill on the Upper Housing.

It is recommended to clean all Humidifiers before use. Refer to
Cleaning Instructions for Base and Jug cleaning.
Use the Carrying Handle on the Water Jug to bring it to a
faucet. The Water Jug has a ‘Quick Fill/Quick Empty’ Spout.
- To fill, hold Jug upside down by the Handle, press down Stopper
  Lever, and fill with cool tap water. Do not use hot water.
Place the filled Water Jug securely in the Base. Water will
pour into the Base automatically until desired amount is
reached.
When gurgling noise stops, check if the Water Jug is empty.
Refill if necessary.
Even though the Humidifier produces approximately 9 gallons in
24 hours, the water capacity is 4.5 gallons (3 FULL Jugs).

Operation:

Turn fan speed knob to desired speed based on your needs.

For fast humidification of a large room or house, set to high
speed.
For normal operation, set to medium speed.
For quiet night-time operation or after reaching desired
moisture level, set to low speed.

FAQ:

Troubleshooting:

Fan not working or Humidifier doesn’t turn on:

 **Probable Cause:** Unit not plugged in or Power

Switch off. Solution: Ensure Unit is plugged in, check
Power Switch, set Humidistat to higher humidity level.

“`

This Owner’s Manual is provided and hosted by Appliance Factory Parts.
LASKO 1129 Owner’s Manual
Shop genuine replacement parts for LASKO 1129
Find Your LASKO Humidifier Parts – Select From 20 Models ——– Manual continues below ——–

TROUBLE
Fan not working or Humidifier doesn’t turn on

TROUBLE SHOOTING GUIDE

PROBABLE CAUSE

SOLUTION

· No power · Humidistat not set correctly

Make sure Unit is plugged in Check that the Power Switch is on Set Humidistat to higher humidity level

Water leaking

· Base is overfilled · Filter is old and dirty

Reduce water level in Base Replace Filter

Foul odor

· Filter needs to be replaced · Base needs to be cleaned · Whole Humidifier needs cleaning

Replace Filter Follow Follow

Filter discoloration

· Mineral deposits in water

Replace Filter

Water discoloration

· Humidifier needs to be cleaned · Hard water – Iron in water · Some humidifier additives can cause
discoloration

Follow Use filtered or distilled water

Lights don’t work: Humidistat Light Off, Power Light On
Power Light Off, Humidistat Light On
No water show

· Humidity is not yet achieved in room
· Room has reached desired Humidity level
· Hose not connected to Pump · Hose not connected to Water Show · No Water in Unit

Let Humidifier continue to run
Set Humidity Knob for more Humidity
Connect Hose to Pump Connect Hose to Water Show Refill Unit

LIMITED WARRANTY
WHAT THIS WARRANTY COVERS: This product is warranted against defects in workmanship and/or materials. HOW LONG THIS WARRANTY LASTS: This warranty extends only to the original purchaser of the product and lasts for one (1) year from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs. WHAT LASKO WILL DO: During the warranty period, Lasko will, at its sole option, repair or replace any part or parts that prove to be defective or replace the whole product with the same or comparable model. WHAT THIS WARRANTY DOES NOT COVER: This warranty does not apply if the product was damaged or failed because of accident, improper handling or operation, shipping damage, abuse, misuse, unauthorized repairs made or attempted, or the use of the product for commercial or nonresidential service. This warranty does not cover shipping costs for the return of products to Lasko for repair or replacement. Lasko will pay return shipping charges from Lasko following warranty repairs or replacement . ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY), LAST ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR CONSEQUENTIAL DAMAGES FROM ANY CAUSE WHATSOEVER, OR (II) REPLACMENT OR REPAIR OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING TO THE CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD. Some states and provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these exclusions or limitations may not apply to you. This warranty gives you specific legal rights. You may also have other rights which vary from state to state and province to province.

FOR PARTS:
For Replacement Parts or Filters please call: 1-800-233-2068, MONDAY – FRIDAY, BETWEEN the HOURS of 8 AM and 4 PM EST. “PLEASE DO NOT RETURN PRODUCT TO PLACE OF PUR-
CHASE.” Reference model number 1129 when you call.
FOR TECHNICAL ASSISTANCE and SERVICE CENTER LOCATIONS:
For any questions, comments or the location of your nearest service center, PLEASE CALL OUR TOLL-FREE “HOTLINE” AT 1-800-233-0268, MONDAY – FRIDAY, BETWEEN the HOURS of 8 AM and 5 PM EST. Please reference model number 1129 when
you call.
Appliance Service Dept. · 300 Confederate Drive, Franklin, TN 37065-0569 PLEASE DO NOT SEND PRODUCT TO THIS LOCATION!

Rev. A 5/07

4

2084473

FILLING
CAUTION: Do not pour water through the Exhaust Grill on the Upper Housing. Doing so may cause damage and personal injury.

CAUTION: · Unplug Unit when filling
· Always place Humidifier on a firm level surface. Locate the Power Cord so the Humidifier is not resting on it, and is away from traffic.
· Be careful not to overfill.
· Do not pour water through Exhaust Grill, doing so may cause damage and personal injury.
· Take extra care to prevent water spillage that may damage furniture or flooring. The manufacturer will not accept responsibility for damage to property caused by water spillage.
· Always be sure the Power Knob is in the OFF position when plugging Humidifier into a grounded 120 volt AC wall outlet.
· To prevent risk of electrical shock and injury to persons, do not plug Humidifier into electrical outlet with wet hands.
1. It is recommended that all Humidifiers be cleaned prior to use. Please read Cleaning Instructions for Base and Jug cleaning.

2. Use the convenient Carrying Handle found on the bottom of

the Water Jug to bring it to a faucet. The Water Jug features a

`Quick Fill/Quick Empty’ Spout. To fill, hold Jug upside down

by the Handle. Use thumb to press down Stopper Lever, and

fill Jug. Fill the Water Jug with cool tap water. Never use hot

water. (Figure 3)

(Jug Holds 1-1/2 Gallons)Carry Handle

Figure 3

Stopper Lever

Quick Fill / Quick Empty
Spout
(Base Holds 3 Gallons)
Water Capacity of Unit is 4.5 Gallons
When the Jug is replaced back into the Base it will quickly empty to fill Base.
NOTE: While carrying filled Water Jug back to the Humidifier, hold the Handle with one hand, while supporting bottom of Water Jug with other hand.
3. Place the Water Jug securely in the Base. If positioned properly, water will quickly pour into Base and automatically stop when reaching desired amount.
4. When gurgling noise stops lift up the Water Jug to see if it is empty. Refill if empty. When the Unit is full some water will remain in the Jug.
5. Even though your Humidifier will produce approximately 9.0 gallons in a 24 hour period*, the water capacity (amount of water the Humidifier will hold at one time) is 4.5 gallons. (3 FULL Jugs).

OPERATION
1. Turn fan speed knob to desired speed.
3- For fast humidification of a large room or house,
approximately 9 gallon per day.*
2- For normal operation. 1- For quiet, night time operation or after desired moisture
level is reached.

Calculations based on ambient room conditions of 70° F and 30% relative humidity in a room of average insulation.
The presence of water flow in the Water Show Window indicates the circulation of water to the Filter.
Figure 4

The correct room humidity display will set itself 10 seconds after the power cord is plugged into a 120 V outlet.
2. Push the humidity set button up or down, to adjust the humidity to the desired level. The desired humidity range is 25% to 95%.
The desired humidity level is displayed in small numbers and the correct room humidity % is displayed in large numbers.
Once the current room humidity level reaches the desired humidity level, the fan will turn off and the humidity indicator light will come on. This light indicates that the humidifier is still on and will again start when the current room humidity level falls below the desired set level.
If the current room humidity drops below 25% or goes above 95%, the display will blink off and on until the current room humidity is within the 30% to 90% range.

1

3

2

Figure 5

3

0 2 1

5

4

1. Fan Speed Knob
2. Humidity Set Button
3. Desired Humidity %
4. Current Room Humidity %
5. Humidity Indicator Light – Light comes on when desired humidity level is the same or lower than current room humidity while the speed knob is in the on position.

Rev. A 5/07

2

2084473