MAYTAG MED7020RU Front Load Electric Dryer Instruction Manual
- July 31, 2024
- Maytag
Table of Contents
REVERSE DOOR SWING INSTRUCTIONS
REVERSE DOOR SWING: SQUARE-SHAPED DOOR
Using a T25 ®† screwdriver, remove the four screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Retain or set aside the four screws.
Using a T25® screwdriver, remove the two screws securing the door strike to the door frame of the dryer. Remove the four screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown.
Position the door with the inside of the door facing up. Using a Phillips
screwdriver, remove the 13 screws securing the inner door to the outer door.
Lift off the inner door and set aside.
NOTE: There is a small release tab on each side of the door. If the inner
and outer door do not separate easily, slide a credit card, putty knife, or
similar flat object between the inner and outer doors at the locations shown
to release the tab.
Using a T25® screwdriver, remove the three screws securing the latch plate and the five screws holding the hinge assembly in place.
Using a T25® screwdriver, reinstall the latch plate and hinge assembly on the opposite sides from which they were removed.
Position the inner door on the outer door assembly. Using a
Phillips screwdriver, secure with the 13 screws removed earlier.
Using a T25 ® screwdriver, reinstall the four screws securing the door hinge to the dryer.
†® T25 are registered trademarks of Acument Intellectual Properties, LLC.
W11685585A
©2024 All rights reserved. Used under license in Canada.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>