KICKSTARTER iForce Chronos Bluetooth Headphone User Manual

July 31, 2024
KICKSTARTER

KICKSTARTER iForce Chronos Bluetooth Headphone

Bluetooth

RIGHT SIDE HEADPHONE

  1. Power On and turn on the Bluetooth: Press and hold the “O” button in the middle for 2-3 seconds. After the voice prompt “POWER ON”, the headphone is in pairing mode with LED indicating light flashes blue and red. If connected, the headphone sound voice prompt “CONNECTED” with the blue light on and flashes occasionally. Otherwise, if the headphone is not connected, the light flashes blue and red with a voice prompt: “DISCONNECTED”.
  2. Music: Press the 0 button in the middle once to pause play; then press once to resume.
  3. Phone Call: To answer a call, press the 0 button in the middle once; to end a call, press the 0 button in the middle once.
  4. Power OFF: Press and hold the middle button “0” for 3 seconds, the indicator light flashes blue and red with the voice prompt “POWER OFF”. The Headphone is powered off.

LED Indicator

LED indicator automatically flashes with audio input, and the flashes stop when the audio is finished.

Charging

  1. When the charging cable is plugged in, the Bluetooth indicator light and vibration indicator light flash blue slowly.
  2. When the device is fully charged, the Bluetooth indicator light and vibration indicator light consistently stay on blue.
  3. When the cable is plugged in, the headphone stops working at once and power off for charging.
  4. Please charge the device immediately once the Bluetooth or vibration stops working.

Volume

RIGHT SIDE HEADPHONE

  1. Press the UP button to increase volume and the headphone sound voice prompt “Di” when the highest volume is reached.
  2. Press the Down button to decrease the volume.
  3. To cut to the next song, press and hold the UP button for 2-3 seconds.
  4. To go back to the previous song, press and hold the Down button for 2-3 seconds.

Vibration

LEFT SIDE HEADPHONE

  1. Press the middle Lightning button once to turn on the vibration, with the vibration indicator light on the Lightning button stays on.
  2. Press the Up button to increase the amplitude of the vibration.
  3. Press the Down button to decrease the amplitude of the vibration.
  4. Double press the middle Lightning button to turn off the vibration, with the vibration indicating light goes out.

MADE IN CHINA

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals