PATPET WF08 Automatic Pet Water Fountain User Manual

: July 31, 2024
: PATPET

Table of Contents

Safety Precautions
Caution
Specifications
Product Diagram
How to Use
How to Clean
Instructions
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PATPET WF08 Automatic Pet Water Fountain

Safety Precautions

Dispose of all packaging materials properly. Keep the poly bags away from children and pets as these bags could cause suffocation.
Do NOT allow children to play with, in or around the pet water fountain.
To avoid injury, please keep close supervision when the appliance is used near children.
Do NOT use the water fountain with pets not able to reach the water tray or with any physical disability.
Do NOT place any foreign object in the water tank.
Do NOT disassemble the pet fountain other than components as instructed in this User Manual.
Do NOT use the pet fountain for anything other than its intended use.
Only use attachments recommended or sold by the manufacturer.
The use of attachments not recommended or sold by the manufacturer may cause an unsafe condition. This product is only suitable for DC output 5V 1A power adapter, please use the power adapter that meets the relevant national and regional standards, otherwise this product will be damaged or cause safety hazards. Do NOT modify the pet fountain.
Do NOT operate any appliance if the unit is malfunctioning or has been damaged. Do not attempt repairs on the device yourself.
Contact our customer service immediately for further instructions’.
Be sure to disconnect the power supply for safety when the appliance is not in use.
Please disconnect the power supply before maintaining and cleaning the machine.
This product is for indoor use only.
This product is not allowed to run without water.
Never pull the electrical power cord to remove the plug from the wall outlet.
If the plug of this device gets wet, turn off the electricity of that wall outlet. Do NOT attempt to unplug.
Check the device afar installation. Do NOT plug in if there is water on the contact points or plug.
To avoid tripping, always positon the power cord out of the way of foot traffic.
Do not use the appliance in the bathroom.
Change the filter every 2 weeks or when the flow rate has noticeable reduced. For two or more cats, you may need to replace the filters more regularly if it becomes blocked.

Caution

Do NOT allow pets to chew on or swallow any parts.
Keep it level and do not knock over the product, otherwise it will cause malfunction or water spilled.
Do not put this product in the dishwasher for cleaning.
Do NOT install or store the pet water fountain where it will be exposed to weather or temperatures below 0°C / 40®F.
Read and observe all important notices listed on the pet water fountain and in the packaging.

Specifications

Product Name : Automatic Pet Water Fountain
Model: WF08
Dimensions: 10.235.127.56inch
Capacity : 2. 5 L
Material : ABS
Rated voltage : 5V lA

Rated power : O.SW
Suggested pet types : cats and small and medium-sized dogs

Product Diagram

How to Use

Please following the steps for initial use.

Soak the filter in clean bowl for 5 minutes with S-S0°C water.
- It is normal for the water soaked in the filter element to appear colorless or yellow, but it is not drinkable.
Rinse the drinking water tray, filter tray and tank with clean water.
- It is strictly forbidden to put this product and its assembly parts in the dishwasher for cleaning, and Do not soak the External water pump in water.
Fill the water Tank with clean and hygienic drinking water, assemble the Filter Tray.
Assemble the Filter and the Fixed Tray.
Insert the External water pump into the Fixed Tray and twist to the left.
Place the assembled water dispenser on a stable ground.
Note: Keep the water level between the Min and Max level. The pump will fail if it runs dry.

How to Clean

The water dispenser needs to be cleaned once about 3 days in operation, and the filter element should be replaced once about2 weeks. The parts of the water dispenser are not allowed to be cleaned in the dishwasher.
When the filter element indicator blinks twice, please replace the filter element in time. After the replacement, double-click the switch button, the indicator will return to normal, and the timer will be reset. The new filter element needs to be soaked in water for about 5 minutes before it can be used.

Instructions

Switch Button:
Long press to power off, Short press to switch modes.
Battery Indicator:
Fully charged white light is always on, low battery red light flashing.
Charging red light and white light flash alternately.

Filter Element Reminder:
The lamp is not on when it does not need to be replaced. When you need to replace it, the indicator blinks twice. Double click the switch button to reset the filter element reminder.

Timing Mode:
Automatically dispense water once every 30 minutes

Induction mode:
when the sensor detects a pet, the machine will automatically discharge water.

The device has been approved for use in EU countries and is therefore provided with the CE mark. All necessary documentation is available on the website: www.electric-collars.com Changes to technical parameters, properties and printing errors reserved.