ELKAY EF1500VRBMC 1500 Gallon Vandal Resistant Retro Fit Filter Kit with Filter Monitor Installation Guide

: July 29, 2024
: ELKAY

Table of Contents

ELKAY EF1500VRBMC 1500 Gallon Vandal Resistant Retro Fit Filter Kit with
Product Information
Product Usage Instructions
FAQ
TOOLS REQUIRED
INSTALLATION STEPS
OPERATING INSTRUCTIONS FOR THE FILTER MONITOR
KEEP THIS SHEET IN A HANDY LOCATION
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ELKAY EF1500VRBMC 1500 Gallon Vandal Resistant Retro Fit Filter Kit with

Filter Monitor

ELKAY-EF1500VRBMC-1500-Gallon-Vandal-Resistant-Retro-Fit-Filter-Kit-with-
Filter-Monitor-FIG-1

Product Information

Specifications:

Model: EF1500VRBMC
Capacity: 1500 Gallons
Type: Vandal-Resistant Retro-Fit Filter Kit
Includes: Filter Monitor

Product Usage Instructions

Tools Required (Not Provided):

Safety Glasses
Gloves
Level
Pencil
Mounting Screws, Anchors, Fasteners

Installation Steps:

Verify all included pieces before starting installation.
Mount the filter box vertically near the water dispenser.
Shut off water and electricity to the water dispenser.
Lift the cover at the bottom and slide upwards toward the top.
Cut a hole in the wall for water lines.
Mount the box to the wall using appropriate fasteners.
Disconnect water inlet from dispenser and connect to the filter head inlet.
Connect poly tubing from dispenser inlet to flow meter outlet fitting.
Install filter on filter head turning clockwise.
Insert batteries into filter monitor and position it for viewing through the front cover window.
Turn on water, check for leaks, and run 1 gallon of water through the fixture to purge air and carbon particles.
Peel protective covering from front cover and install it onto the box.

FAQ

Can this filter kit be used outdoors?
No, this is designed for indoor use only as per the manufacturer’s instructions.
What type of batteries does the filter monitor use?
The filter monitor uses 2 AA batteries.
How often should the filter be replaced?
Refer to the manufacturer’s guidelines for filter replacement intervals based on usage.

IMPORTANT
THIS IS AN INDOOR APPLICATION ONLY. ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON.

TOOLS REQUIRED

BUT NOT PROVIDED:

SAFETY GLASSES
GLOVES
LEVEL
PENCIL
MOUNTING SCREWS, ANCHORS, FASTENERS

INSTALLATION STEPS

Before starting your installation, verify that you have the following included pieces.
- 1 Pinned Torx Bit
- 2 AA Batteries
- 1 Pinned Torx Screw
- 3.5 Feet of Poly Tubing
Find a location to mount your new filter box near the water dispenser to which it is being connected. For accurate monitoring, the filter box should be mounted vertically as shown (Fig. 2, page 2).
Shut off the water and electricity to the water dispenser.
Lift the cover at the bottom and slide upwards toward the top.
Take the filter box and place on the wall in the desired location. Be sure that the box is positioned vertically on the wall as shown. The arrow on the water monitor valve should always be pointing UP (Fig. 4). Make sure the filter box is level, take a pencil and mark around the inside opening and the mounting locations. If the water will not be coming thru the wall into the back of the filter box, knock-outs have been provided to allow the water lines to run thru the sides or bottom. NOTE: If running the water lines thru the knockouts, use the appropriate protection (not provided) to keep the lines from getting cut.
Cut a hole in the wall anywhere inside the marked location to allow room for the water lines to come into the back of the box.
Remove any protective covering from the outside of the filter box.
Using the appropriate fasteners (Not Supplied), mount the box to the wall.
Disconnect the water inlet from the water dispenser and connect to the inlet copper tube on the filter head.
Connect the poly tubing from inlet of the water dispenser to the outlet fitting on the flow meter.
Remove the red cap from the filter and install on the filter head turning clockwise.
Remove the filter monitor from the back of the box and insert the supplied batteries. Once installed, the monitor will light up. The monitor can now be put back on the back of the box. Make sure it is positioned so that it can be viewed thru the window in the front cover once it is installed.
Turn on the water and check for leaks. Repair as needed
Run approximately 1 gallon of water thru the fixture. This flushing procedure purges air and fine carbon particles from the filter. After 1 gallon of water has been purged carefully inspect all water connections for leaks
After peeling the protective covering from the front cover, hook the tabs on the top into the slots on the top of the box. Slide the cover down and install the supplied screw. Once done keep the bit as it will be needed for replacing the filter.

OPERATING INSTRUCTIONS FOR THE FILTER MONITOR

The filter monitor backlight automatically turns on when there is water flowing through it. The blue backlight will turn off after approximately 10 seconds but will display the remaining capacity the entire time water is flowing. To conserve battery life, the display will automatically turn off in 10 seconds when there is no water flowing. The power of the two batteries could last for approximately one year.
The flow meter will generates an audible alert and the digits on the LCD will blink red when the remaining capacity reaches zero.
To reset, press the reset button for four seconds. The “RESET” on the LCD blinks twice and the remaining capacity is reset to the original programming value.
When the battery power is low the monitor generates an audible alert and the empty battery symbol on the upper right corner blinks. The alert status will be released when the batteries are replaced with new one. NOTE: the data of the last status will be memorized when powered off.
NOTICE
To receive maximum benefit from your ELKAY WaterSentry® filters, note the installation dates below and change according to the following guidelines.
ELKAY Part No. 51299C WaterSentry® VII — Lead Reduction Filter Change every 1,500 gallons, or once a year — whichever occurs first.