LANDMANN 28338 Big Sky Owner’s Manual

: July 31, 2024
: LANDMANN

Table of Contents

References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LANDMANN 28338 Big Sky Owner’s Manual

Find Your Landmann Fireplace Parts – Select From 49 Models

ASSEMBLY INSTRUCTIONS

PLEASE READ ALL RULES FOR SAFE OPERATION BEFORE ASSEMBLY AND HELPFUL HINTS BEFORE USE.

Assembly and Use Instructions for Models:
28335
28336
28337
28345
28346
28347
28348
28338
28339
28340
28341
28342
28343

READ FIRST!
RULES FOR SAFE OPERATION

FOR OUTDOOR USE ONLY!
USE ONLY ON BRICK, CONCRETE, STONE OR OTHER MASONRY SURFACES!
DO NOT USE ON LAWNS, WOODEN DECKS OR ASPHALT!
KEEP BIG SKY AWAY FROM BUILDINGS, FLAMMABLE ITEMS AND VEHICLES.
THE BIG SKY FIRE PIT IS FOR ADULT USE ONLY.
DO NOT LEAVE UNATTENDED AT ANY TIME WHILE IN USE.
KEEP SPARK GUARD ON BIG SKY WHILE IN USE.
DO NOT USE IN WINDY CONDITIONS!
DO NOT OVERLOAD OR USE FOR BURNING GARBAGE.
NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START FIRES.
NEVER USE UNDER LOW HANGING TREE BRANCHES, TRELLIS, OVERHANGS OF ANY KIND INCLUDING COVERED PORCHES.
USE CAUTION WHEN TENDING THE FIRE, AS SURFACES WILL BE HOT WHILE IN USE.
BEFORE EACH USE MAKE SURE BIG SKY IS IN GOOD WORKING CONDITION.
USE CAUTION AFTER THE FIRE HAS BEEN EXTINGUISHED, SURFACES WILL REMAIN HOT FOR SOME TIME.

PARTS LIST:

When unpacking the Big Sky from the carton, make sure you find and become familiar with all the pieces listed below:

TOOLS NEEDED FOR ASSEMBLY:
• Adjustable Wrench, Phillips Screw Driver •

ASSEMBLY INSTRUCTIONS:

STEP 1
Take each of the (3) legs and bolt them to the fire pit (as shown in the diagram to the left) using (6) washers and (6) nuts. Tighten securely!

STEP 2
Assemble (1) ring section to the fire pit using (2) bolts, only loosely tighten the bolts.

STEP 3
Repeat STEP 2 for the remaining (2) ring sections. Make sure the (3) ring sections fit together to form a continuous ring. Tighten all bolts securely!

STEP 4
Take each of the (3) cooking grate pins and thread them into the nuts welded on the inside of the fire pit. Do not over tighten!

STEP 5
Place spark guard on cooking grate pins. The spark guard purpose is to keep sparks contained in the fire pit. PLEASE USE at all times.

STEP 6
Before using you must place 5 lbs of sand on the bottom of the fire pit. The sand insulates the area below the pit and protects against the corrosive nature of the ashes.

MULTI-PURPOSE POKER
The poker can be used not only for shifting and tending the fire, but also for removing the cooking grate, lifting off the spark guard or pulling Big Sky to another location.

HELPFUL HINTS FOR USAGE

ADDING SAND TO THE BOTTOM OF FIRE PIT HELPS PROTECT AGAINST THE CORROSIVE NATURE OF THE ASHES AND WILL EXTEND THE LIFE OF THE PIT.
BURN YOUR FIRE PIT 3 TIMES BEFORE USING TO COOK ON.
STORE AWAY OUT OF THE WEATHER AND ELEMENTS.
DO NOT LET YOUR FIRE PIT FILL WITH WATER.
DO NOT DUMP ASHES WHERE THEY COULD START A FIRE.
DISPOSE OF ASHES IN PROPER RECEPTACLE ONLY AFTER ASHES HAVE COOLED.

COOKING GRATE

If you would like to grill, place the cooking grate on cooking grate pins.
PLEASE NOTE: Please remove cooking grate when not grilling.

SANDPAINT FINISH

Note: Since the heat intensity from the fires will vary depending on the type and amount of fuel used, you may experience minimal peeling or flaking of the paint. This is normal and will not affect the safety or performance of this fire pit.

Congratulations on your purchase of the Big Sky Fire Pit! At Landmann
USA, we strive to provide you with an easy to use, easy to assemble product. However, in the unlikely event your package should have a missing or defective part, please contact us at:
customerservice@landmann-usa.com
-OR- 1-800-321-3473 M-F 8-5 Eastern Time
Proof of purchase may be required. Thank you!

Landmann USA
Cartersville, GA 30120
Made in China
© 2009 Landmann USA
Big Sky® and Landmann® are registered trademarks of Landmann® USA.