dormakaba Saffire LX-P Smart Locks Instructions

: July 25, 2024
: dormakaba

Table of Contents

dormakaba Saffire LX-P Smart Locks
Product Specifications
Product Usage Instructions
Frequently Asked Questions
BACKSET ADJUSTMENT FOR 3° BEVEL DOOR
Read User Manual Online (PDF format)
Download This Manual (PDF format)

dormakaba Saffire LX-P Smart Locks

Product Specifications

Product Models: Saffire LX-P & Saffire EVO LZ-P
Exit Door Preparation: PRECISION 5100/5200, VON DUPRIN 22
Backset Adjustment Range: 0.250 [6.4] to 0.500 [12.7]
Door Thickness Range: 2.750” [70mm] to 3.000” [76.2mm]
Thread Class / Filet Finish: SAE: 2A-2B, ISO: 6g / 6H
Angle: 1

Product Usage Instructions

Installation Steps:

Refer to the exit device manufacturer’s installation instructions for cut-out details.
Adjust the backset according to the exit device manufacturer’s specifications.
Ensure the door thickness falls within the range specified for proper installation.
Follow the specific tolerances and distances mentioned in the manual for accurate installation.

Door Preparation:

Ensure the door has the necessary backset adjustment dimension as per the product specifications. Use appropriate tools to create the required cut-outs for the exit device and mortise lock.

Hardware Installation:

Install the Saffire LX-P or Saffire EVO LZ-P hardware components securely onto the prepared door following the provided instructions. Pay attention to the handedness (right or left) and bevel orientations for correct placement.

Frequently Asked Questions

Q: What should I do if my door thickness is outside the specified range?

A: If your door thickness exceeds the specified range, consult with a professional installer or contact customer support for guidance on how to proceed with the installation.

Q: Can I adjust the backset after installation?

A: It is recommended to set the backset correctly during the initial installation process. Adjusting it post-installation may require additional tools and expertise.

INSIDE

DIMENSIONS = IMPERIAL

3D FILE GOVERNS ALL UNSPECIFIED DIMENSIONS & GENERAL TOLERANCES APPLY

GENERAL TOLERANCE, UNLESS OTHERWISE SPECIFIED

BACKSET ADJUSTMENT FOR 3° BEVEL DOOR

PRECISION 5100/5200, VON DUPRIN 22 exit door preparation

NOTES:

FOR EXIT DEVICE AND MORTISE LOCK CUT-OUT REFER TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS.
BACKSET SHOWN FOR REFERENCE ONLY, ADJUST BACKSET TO EXIT DEVICE MANUFACTURER
INSTALLATION INSTRUCTIONS. BACKSET TO BE ADJUSTED TO LOW AND HIGH BEVEL DOOR EDGE AS
PER BACKSET ADJUSTMENT TABLE.
DIMENSIONS ARE SYMETRICAL ABOUT UNLESS OTHERWISE NOTED.
FOR SURFACE MOUNT VARIANTS PLEASE REFER TO IP-516418-15 FOR THE PLACEMENT OF HOLE 0.750″
& CABLE GROOVE 0.250″. HOLES 2×0.250″ NOT REQUIRED.
GROOVE TO BE DONE ONLY IN SOLID DOORS. TO PASS WIRES INSIDE THE DOOR FOR HOLLOW DOORS.
REFER TO SPECIFIC TOLERANCES TABLE FOR DIMENSIONS MARKED WITH #.
DRAWING IS NOT TO SCALE.
DIMENSIONS ARE IN INCHES [mm].

WARNING

To verify lock coverage and door operation meets expectations, dormakaba strongly recommends completing a full door mockup.
This will ensure that all necessary products and parts for a successful installation are included.
Always validate that you have selected the correct template for specific lock model being installed. The same lock model can be offered with different locking device options.
Drawing is not to scale. Measurements are for reference only. Not a drilling template.
If you have any questions, please contact your local sales representative or authorized reseller.

“`