HOFTRONIC 5421000 Series LED Streetlight User Manual
- June 3, 2024
- HOFTRONIC
Table of Contents
USER MANUAL
LED STREETLIGHT
| 5421372 | 5421396 | 5421419 | 5421433 |
|---|---|---|---|
| 5421389 | 5421402 | 5421426 | 5421440 |
IMPORTANT SAFETY DETAILS
- Ensure the AC/Mains power is NOT connected and cannot be unexpectedly reconnected during installation.
- This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical and safety regulations relevant to the country it is being installed.
- This product may NOT be installed by minors or people with a mental disability.
- Do not wire this lantern into the lighting circuit, use a swtiched fuse spur.
- Carefully observe all instructions of warnings that are labelled on, or supplied with your product.
- This product is suitable for outdoor use. If in any doubt, consult a qualified electrician.
DIAGRAM
INSTALLATION DETAILS
- Do not wire this lantern into the lighting circuit, use a switched fuse spur.
- Before installation and servicing, disconnect the electrical supply at the mains.
- Carefully observe all instructions or warnings that are labelled on, or supplied with your product.
- Please note: For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intented mounting point for this product before proceeding with the installation.
Important warning
Please read the instructions carefully before installation and preserve it
well. Recommend the lamp must be installed and assembled by a qualified
electrician. Before installation, please cut off the main power. Turn off the
circuit. Do not turn the lamp on before the end of the installation. Please
use proper wire for connection. The lenght of output leads should be typically
0.5m-2m in order to keep radio interference minimum. The adapter size is Ø62mm
Note
This product whould be disposed of responsibly at the end of its life. Please
recycle where facilities exist. Check with your local Authority or retailer
for recycling advice.
INTENDED USE / APPLICATION
Product designed for the use in households and for other similar general applications.
MOUNTING
Technical changes reserved. Read the manual before mounting. Mounting shouldbe performed by an appropriately qualified person. Any activities to be done with disconnected power supply. Exercise particular caution. Product has a protectivecontact/terminal. Failure to connect the protective lead may lead to electric shock.Mounting diagram: see pictures. Check for proper mechanical fastening and connection to electrical power prior to first use. The product can be connected toa supply network which meets energy quality standards as prescribed by law. To maintain the proper IP protection level, the right diameter of the power cable shouldbe selected for the cable gland used in the product.
FUNCTIONAL CHARACTERISTICS
Product can be used outdoors.
USAGE GUIDELINES / MAINTENANCE
Any maintenance work must be performed when the power supply is cut off and the product has cooled down. Clean only with soft and dry cloths. Do not use chemical detergents. Do not cover the product. Ensure free air access. Product may heat up to a higher temperature. Product can only be supplied by rated voltage or voltage within the range provided. It’s forbidden to use the product with damaged protectivecover. Product must not be used in unfavourable conditions, e.g. dust, water,moisture, vibrations, explosive air atmosphere, fumes, or chemical fumes, etc. Nondemountable product. Not suitable for independent repairs.
ENVIRONMENTAL PROTECTION
Keep your environment clean. Segregation of post-packaging waste is recommended. This labelling indicates the requirement to selectively collect waste electronic andelectrical equipment. Products labelled in this way must not be disposed of in the same way as other waste under the threat of a fine. These products may be harmfulto the natural environment and health, and require a special form of recycling/ neutralising. Products labelled in this way should be returned to a collection facility for waste electrical and electronic goods. Information on collection centres is provided by local authorities or sellers of such goods. Used items can also be returned to the seller when new product is purchased, in quantity no larger than the purchased item of the same type. The above rules regard the EU area. In the case of other countries,regulations in force in a given country must be applied. Contacting the distributor ofour products in a given area is recommended.
COMMENTS / GUIDELINES
Failure to follow these instructions may result in e.g. fire, burns,
electrical shock,physical injury and other material and non-material damage.
For more informationabout Hoftronic products visit
www.hoftronic.com. Hoftronic shall not be
responsiblefor any damage resulting from the failure to follow these
instructions. Hoftronic reserves the right to make changes in the manual – the
current version can bedownloaded at
www.hoftronic.com.
DECLARATION OF CONFORMITY
DOCUMENTATION
This product has been manufactured and supplied in compliance with all
relevant regulations and directives applicable to all member states of the
European Union. The product complies with all applicable regulations and rules
in the country of sale. Formal documentation such as the declaration of
conformity, the safety data sheet and the product test report is available
upon request.
CE DECLARATION
The product complies with the following directives:
LVD: 2014/35/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
The complete Declaration of Conformity Document (DOC) is available upon
request.
Imported by
HOF Trading B.V.
Fahrenheitstraat 11, 6003 DC Weert , The Netherlands
Made in P.R.C.
www.hoftronic.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>