Nero NR401CH Wall Mount Sensor Tap Installation Guide
- July 17, 2024
- Nero
Table of Contents
Nero NR401CH Wall Mount Sensor Tap
Drawing
Specifications
Watermark License
WM-060073
Temperature Rating
Min 1 ·c-Max 75″C
Pressure Rating
Min 150kpa – Max 500kpa
Packaging Includes
- 1x Sensor Tap
- 1x Control Box
- 1x Power Adapter
- 1x Plate
Finish & SKU
| Chrome
NR401CH
---|---
| Gun Metal
NR401GM
| Brushed Bronze
NR401BZ
| Brushed Nickel
NR401BN
| Matte Black
NR401MB
| Brushed Gold
NR401BG
| Matte White
NR401MW
*Dimensions are nominal measurements only.
Parts Name
Water connect
-
Water outlet hose connect
Connect the spout with control box by flexible hose, -
Water inlet hose connect
Connect G1/2 water supply hose with water inlet
Note: Be sure no water leakage after connecting water
Install Spout
Signal line connect
Connect signal line with control box, then screw tightly
Note: Should keep the signal line clear and dry, be sure to work normally
Installation control box
-
Put the control box on wall, drill four holes, then insert the plastic bulged tube
-
Fix the control box on wall by screw
Note:
- Please close the water supply and power supply before install.
- Be sure to install control box correct, don’t put upside down.
- For easy to maintain, should be choose the suitable place install control box.
Meanwhile, It must less than 50cm distant from the basin.
(Please check the following picture)
The installation drawing of control box
Clear sensor window
After installation, wipe sensor window by soft dry cloth to keep it clean
Power connect
-
AC: Connect the transformer
-
DC: Put in 4AA alkaline battery into the battery box.
Detect distance
ATTENTION : After initial installation , pis remember to hold down the red reset button for 2 seconds to enable sensor to learn the IR distance to sink.
Note:
It is normal if there is sound of opening & closing solenoid valve whe it is
under self-adjustment condition.
Customers Support
info@nerotapware.com.au
nerotapware.com.au
11-13 Buontempo Road
Carrum Downs Vic 3201