Lasko 7050 25 Inch Misto Outdoor Misting Fan at Tractor Instruction Manual

Lasko 7050 25 Inch Misto Outdoor Misting Fan at Tractor

Register Your Product Today www.lasko.com/product- registration/

You will benefit from:

• Efficient and enhanced support
• Future product updates

Have a Question? Need a Part?
Please Do Not Return Product to Store! Contact Lasko Customer Service: 800-233-0268 Monday-Friday 8AM – 5PM EST. (Valid in the USA, its Territories, and CANADA Only)

READ AND SAVE THESE INSTRUCTIONS
Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. failure to comply with instructions could result in personal injury and/or property damage! This Fan is for residential use only. It is not intended to be used in commercial, industrial or agricultural settings.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, these instructions and warnings should always be followed to reduce the risk of fire, electrical shock and injury to persons:
Read all instructions before using this Fan.

1. This Fan is an outdoor product and is NOT intended for indoor use. Do not leave the misto Fan unattended when it is plugged in.
2. Make certain the power source conforms to the electrical requirements of the Fan. Completely assemble the Fan before connecting to power source. Do not use the Fan with any solid state speed control.
3. Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. Never place the Fan where it may fall into a water reservoir such as a Pool or water container. Do not hang the misto Fan on a wall or ceiling or use in a window.
4. The misto Fan should not be used as a toy. To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where children can reach it.
5. Turn off the misto Fan and unplug power cord before installing, servicing, or moving the Fan. DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN.
6. This Fan must NOT be used in potentially dangerous locations such as flammable, explosive, chemical-laden or where gasoline, paint
7. CAUTION: Surfaces in ee area ate Fan may become slippery when wet The power cord is equipped with a three-prong, grounded GFCI (Ground Fault Circuit Interrupter) plug that must be inserted into a grounded receptacle. Under no circumstances must the grounding prong be cut off the plug.

WARNING: Do not use a three-prong to two-prong adapter.Where a two-prong wall receptacle is encountered, it must be replaced with a properly grounded three- prong receptacle installed in accordance with the National Electrical Code (NEC) and all applicable local codes and ordinances. This work must be done only by a qualified electrician, using copper wire only. The GFCI Fan cord set can be plugged into an existing GFCI outlet if present.

WARNING RISK OF ELECTRIC SHOCK. TEST GFCI PLUG BEFORE EACH USE.

• PLUG GFCI INTO POWER OUTLET. INDICATOR LIGHT SHOULD TURN ON.

• PRESS TEST BUTTON. INDICATOR LIGHT SHOULD TURN OFF.

• PRESS AND RELEASE RESET BUTTON. INDICATOR LIGHT SHOULD TURN ON.
  IF ABOVE TEST FAILS, DO NOT USE THIS GFCI FAN. CALL 800-233-0268, MON – FRI, 8:00 A.M. AND 5:00 P.M. EASTERN USE OF A THREE-PRONG TO TWO-PRONG ADAPTER IS NOT PERMITTED. IMPROPER CONNECTION MAY CREATE THE RISK OF ELECTRICAL SHOCK. USE OF SUCH ADAPTERS IS NOT PERMITTED IN CANADA.
  This plug is a safety feature. It contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged. To reduce the risk of fire, electric shock and personal injury, DO NOT remove, replace, repair or tamper with the originally supplied plug or GFCI. If the Fan does not function properly, it may be due to the safety device incorporated in this plug.
  Call 800-233-0268, Monday – Friday, between 8:00 a.m. and 5:00 p.m. Eastern. If the plug warning label is missing or damaged, call the toll free number for a replacement label.

• NEVER operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or damaged in any manner. This GFCI plug does not protect against electrical shock due to contact with both circuit conductors or a fault in any wiring supplying this device. DO NOT use an extension cord between the Fan GFCI cord and power outlet. Customer service is available at 800-233-0268, Monday through Friday, 8am to 5pm to answer your questions.

• DO NOT USE an extension cord with this Fan.

• Prior to use, inspect for debris and/or insects.

• NEVER insert or allow fingers or foreian objects to enter any ventilation or exhaust openina as it may cause an electric shock or fire. or damage the Fan. To reduce the risk of fire, DO NOT block or tamper with the Fan in any manner while it is in operation.

• Turn off water at the source before changing the nozzle.

• Turn off water at the source after each use. Disconnect your garden hose from the valve adapter and drain unit to winterize.

• ALWAYS place the Fan on a stable, flat, level surface when operating, to avoid the chance of the Fan overturning. Locate the Power Cord so the Fan or other objects are not resting on it. DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or similar coverings. DO NOT route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.

• DO NOT use this Fan in close proximity to cooking grills, fire pits or other open flames.

• The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.

• This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008, or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings. THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008). 18. This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for Hazardous locations. THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008).

WARNING REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED CONTROL DEVICES.
SAVE THESE INSTRUCTIONS

Parts Included

1. Fan

Assembly

Attach the Hose Valve adapter to any garden hose or spigot

Operation

1. Turn the Fan on by selecting the desired speed with the Power Knob on the side of the Fan. 0 – Off, 3 – High, 2 – Medium, 1 – Low
2. Valve Adapter to the source postite.

Louver Oscillation

To operate internal air directing Louvers:

1. Turn the Power Knob to the desired speed setting.
2. Push the Louver Switch to the On (l) to oscillate louvers.

Louvers will stop operating when:

1. Power to the unit is unplugged.
2. Power Knob is in 0 – Off position.
3. Louver Switch is in Off (0) position.

To center Louvers in Air Flow:

1. Observe Louvers during operation. Once centered, place Louver Switch in Off (0) position.

Cleaning and Care Guide

If the nozzles become clogged from contamination, follow the steps below:

1. Turn the water off at the source.
2. Remove the misting assembly’s valve adapter from garden hose or spigot and the hose adapter. Do this carefully and allow residual water pressure to drain. Cycle (turn the handle back and forth) the valve and ensure freedom of movement and that there is no debris blocking the water’s path.
3. Remove the Screen Filter from inside the Misting Assembly Valve Adapter. Inspect and ensure the Screen Filter is free of buildup or debris. If filter is clogged, soak in a solution of undiluted 5% acidity distilled white vinegar for at least 2 hours. For an immediate solution, replace the Filter.
4. Carefully remove each Misting Nozzle from the Nozzle Housing by turning it counter-clockwise using your hand or, if required, a pair of pliers. Soak the Nozzles in a solution of undiluted 5% acidity distilled white vinegar for at least 2 hours. For an immediate solution, replace the Nozzles with the supplied replacement parts. The 3 Misting Nozzles supplied in the plastic bag with this instruction manual are Low Flow Misting Nozzles. They are identified by the marking “FE-1/8” on the face. These Nozzles will reduce the amount of misting action by approximately 30% (percentage varies based on supply water pressure). If more Nozzles are required, call 800-233-0268, or order online at www.lasko.com in Parts & Accessories.
5. After the appropriate amount of soak time for the parts requiring cleaning, reassemble the misting subsystem by inserting the Misting Nozzles into the Nozzle Housing and turning clockwise until secure. Only turn until hand tight; do not over tighten. Next, return the Screen Filter to the inside of the Misting Assembly Valve Adapter. Finally, reattach the Valve Adapter to the Hose Adapter.
6. You are now ready to continue to stay cool with your misto”” Outdoor Misting Fan.

MAINTENANCE

WARNING:
To reduce the risk of electrical shock and fire please observe the following instructions:

• Always unplug the cord before moving, servicing or cleaning.
• NEVER place the Fan in or near water.
• Clean the Fan only with a vacuum equipped with a brush attachment; the vacuum will remove the lint and dirt from inside the Fan.
• NEVER attempt to take apart the Fan.
• Clean the body of the Fan with a soft cloth only.
• NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or other harsh cleaners.

TROUBLE SHOOTING

TIPS If your Fan fails to operate, see below for a list of probable causes and solutions: Be sure the power cord is plugged into a working electrical outlet.
SERVICING: For servicing, other than general user maintenance, please contact Customer Service at 800-233-0268, Monday through Friday, from 8am-5pm Eastern.
STORAGE: Store the Fan with these instructions, in the original carton in a cool, dry place.
LUBRICATION: Motor is permanently lubricated.
DISPOSITION: Corrugated packaging materials are recyclable. For environmentally responsible disposal of this product, contact your local waste service provider or visit www.1800recycling.com®.

LASKO PRODUCTS, LLC LIMITED WARRANTY (VALID IN THE USA, ITS TERRITORIES,

AND CANADA ONLY)

WHAT THIS WARRANTY COVERS:
This product is warranted against defects in workmanship and/or materials.

HOW LONG THIS WARRANTY LASTS:
This warranty extends only to the original purchaser of the product and lasts for one (1) year from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs.

WHAT LASKO WILL DO:
During the warranty period, Lasko will, at its sole option, repair or replace any part or parts that prove to be defective or replace the whole product with the same or comparable model. For all warranty claims, the product must be returned to Lasko Products, LLC at customer expense with proof of purchase within the warranty period. Contact the Lasko customer service department to obtain a Return Authorization (“RA”). DO NOT return products without an RA or the warranty claim will not be processed.

WHAT THIS WARRANTY DOES NOT COVER:
This warranty does not apply if the product was damaged or failed because of accident, improper handling or operation, shipping damage, abuse, misuse, unauthorized repairs made or attempted. This warranty does not cover shipping costs for the return of products to Lasko for repair or replacement. Lasko will pay return shipping charges from Lasko following warranty repairs or replacement. ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY), LAST ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE I) INCIDENTAL OR CONSEQUENTIAL DAMAGES FROM ANY CAUSE WHATSOEVER, OR (I) REPLACEMENT OR REPAIR OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING TO THE CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD. Some states and provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these exclusions or limitations may not apply to you. This warranty gives you specific legal rights. You may also have other rights which vary from state to state and province to province. Proof of purchase is required before a warranty claim will be accepted
CUSTOMER SERVICE: Toll-Free 800-233-0268. Email: producthelp@lasko.com Our Customer Service team is available to assist you with product and service questions, and replacement parts. They can be reached Monday through Friday, 8am-5pm Eastern. Please have your model number available, as well as the type and style (located on the underside of your product). Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380 (Please do not send product to this location) www.lasko.com Manual printed in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>