Haloview BTC128, BTC129 Wireless FHD 1080P Rear View Camera with Monitor System User Manual
- June 3, 2024
- Haloview
Table of Contents
Haloview BTC128, BTC129 Wireless FHD 1080P Rear View Camera with Monitor
System
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines,
This equipment should be installed and operated with a minimum distance between 20cm the radiator your body: Use only the supplied antenna.
BTC130 Camera
BTC130 Rear Light Camera Package Contents:
- Manual
- 3.5dBi 2.4G Antenna x 1 PC
- PB Stainless steel flat tail screws M2.6*8mm (4PCS)
- PA Stainless steel Philip’s head screw M4*18mm (4PCS)
- Terminal Cap x 3PCS
Figure1/Figure2/Figure3: Remove Rear Light From the vehicle with straight screwdriver
Figure4/Figure5/Figure6: Remove the rear light and pull out the cables
Figure7/Figure8: Cutting the cables by a plier and stripping the cables to expose the conductive core
Figure9/Figure1 O: Secure the rear light camera base on the vehicle wall, aligning to the pre-install mounting holes.
Figure11/Figure12: Ensure correct polarity when wiring the cables. Red+ Black
Figure13/Figure14: Wire connections and terminals must be sealed and waterproof.
Figure15/Figure16/Figure17: Clamp the terminal tightly to make sure they are sealed and waterproof.
Figure18/Figure19: Put the wires and terminals into hole and fasten the rear light camera into base.
Figure20/21/22: Remove the cover of rear light camera and secure the base with four provided screws. Finally put back the cover.
CAMERA SPECIFICATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>