AiFMY X11S Bone Conduction Headphones User Guide
- July 11, 2024
- AiFMY
Table of Contents
X11S
User Guide
Pairing
- Press and hold the power button for 2 seconds Lo start the headset and enter the pairing state(red/blue lights flash).
- 0pen the mobile phone bluetooth to search for X11S biuetooth device and click to connect. The blue lights is always on after pairing.
Power Button
ON/OFF: Press and hold for 2 seconds
Play/pause music:Click once
Coming call, Answer/hang up:Click once
Reject call:Press and hold for 2 seconds
Switch the bluetooth/MP3 mode: double click(The memory version)
+
Add volume:short press.
Last song: long press
–
Reduction volume:short press
Next song: long press
Charging
Connect the included charging cable to a 5V USB charger for charging, and the red light will urn on when charging, while the red light will urn off when fully charged
Download the song (The memory version)
When the headphones are turned off, use a data cable to connect them to the
computer.Connecting a phone requires an OTG adapter. After connecting, the
computer or phone can read the earphone memory. The song supports MP3/WAV
format.
Tips
Headset should not be soaked in seawater/salt water for a long time. After
use, they should Rinse and dry with fresh water, as the charging magnetic
suction partis prone fo corrosion.
Please wipe the surface of the earphones clean with water after each exercise,
especially It is the charging magnet position, which should be cleaned in a
timely manner o prevent sweat Corrosive charging port, affecting product
lfespan.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device. pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by oné or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>