JVA WA20 Solar Wi-Fi Anywhere Kit User Guide

June 5, 2024
JVA

JVA Solar Wi-Fi Anywhere Kit Quick Start Guide
WA20
PTE2700

The JVA Logo is a registered trademark of JVA Technologies © JVA Technologies

Introduction

The PTE2700 JVA Wi-Fi Anywhere (WA20) provides an integrated Wireless Cellular USB Dongle (Wingle) power supply with a solar battery charger and management system.
This product provides a Wi-Fi network wherever a 3G/4G signal is available*. The Wi-Fi can then be used to connect an IP device or Internet of Things (IoT) device to the Cloud (Internet).
The JVA Solar Wi-Fi Anywhere is paired with the Wingle at the factory, all you need to do is:

  1. Register the SIM card
  2. Connect any Wi-Fi enabled device to the network provided

This quick-start guide explains how to connect your WA20 and connect a battery ready for Wi-Fi connections.
*An external cellular antenna (included) may be connected to increase reception. An upgraded YAGI style antenna is available from sales@jvafence.com.au

Specifications

Component

|

Information

---|---
Solar Panel| Nominal 12v Solar Panel (maximum open-circuit voltage – 22v DC)
Maximum Power 20W
Battery| Nominal 12.8v DC
Minimum Battery size 18Ah
A larger battery may be required if any additional 12v device is connected to the battery
Outputs(1)| 12v DC SAE Connector
Used for powering an external device
Component| Information
---|---
Outputs (2)| 12v DC Battery Connector
Alligator clips for battery connection
SIM| Full Size
Wi-Fi| 2.4GHz b/g/n
Up to 10 connections at a time
Network (Huawei E8372)| 3G 850/2100MHz
4GX 700MHz + 4G B1/3/7/21
Antenna Connector| Female SMA
Ensure the antenna is mounted away from sources of interference such as AC or high voltage cables.

Troubleshooting

Fault

| Likely Cause|

Remedy

---|---|---
No lights are on| Power is not connected
Power wires are re- versed| Check power connections
Check battery polarity
Batt level flashing| Battery disconnected
Bad battery| Check battery connections
Check battery voltage
USB_5V LED off| USB device drawing too much current| Unplug the USB device, check for damage/ seek manufacturer advice

Fault

| Likely Cause|

Remedy

---|---|---
Battery not charging| Solar wiring backward| Check that the Solar + goes to the left-hand screw terminal
| Broken cables| Check that the battery cables are not dammed- aged
| Solar panel broken| Check solar panel for physical damage (broken glass, bent frame, etc.)
Cannot connect to Wi-Fi| The low signal from 3G/4G| Check the management page of Wingle
| Out of Wi-Fi range(~10m)| Move closer to Wingle
| SIM card not inserted correctly| Re-insert SIM card

If the unit is still not working correctly, contact your nearest JVA distributor for technical support.

Before you start

Activate the SIM card
Activate your SIM card and test it in a mobile phone. The Wi-Fi network allows a data-only connection, the number of devices connected to the module will determine how much data will be used.
As a guide, a single IP Energiser or IP Monitor will use less than 1MB per day, so for connecting a single IP Energiser, an upper limit of 500MB per year is an option with a lot of headroom.

Mounting WA20

The WA20 includes a built-in star picket mount, utilise this to keep the solar panel facing north to get full sun from morning to evening.
Overview

LED Indicators

D1 (Solar)| Solid on when the solar panel in sunlight
Blinking when the solar panel in low power conditions Off when no solar power is detected
---|---
D6 (USB_5V)| Solid on when USB Power is turned on
Batt Level| Bottom LED flashes if no battery is disconnected or bad Shows battery level from bottom to top: 25% to 100%

Battery Connection and First Power On
Connect the battery to the PTE2701 by the included battery connection cables. Ensure that the positive is connected to the red connector and the negative to the black connector.
Once connected, the Batt Level indicator lights will show the approximate voltage level of the battery.

JVA Distributors
If you have questions or need further assistance, please email us at sales @jva-fence.com.au or call

Region

| Number
---|---

Australia

|

0731 030 582

South Africa|

0861 782 349

World Wide|

+61 731 030 582

For more information on our complete range of electric fencing products please see the JVA website at https://www.jva-fence.com.au

Tel : +61 (0)499 000 455
Email : sales@jva-fence.com.au
www.jva-fence.comhttps://www.jva- fence.com.au/docs/PTE2700_WA20_Quick_Start_Guide_(web).pdf
The JVA Logo is a registered trademark of JVA Technologies © JVA Technologies

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals