Humanscale M21M33CSBTBNA Mounting Arm For Monitor Installation Guide
- July 10, 2024
- Humanscale
Table of Contents
Humanscale M21M33CSBTBNA Mounting Arm For Monitor
Product Specifications
- Model: HSM21SDWMI0418
- Manufacturer: Humanscale
- Mounting Type : Direct Wall Mount
- Range of Motion : Adjustable
- Material: Plastic and Metal
Product Usage Instructions
Step 1: Prepare for Installation
Remove the plastic front cover from the mount.
Step 2: Separate Mounting Plate
Remove the two side screws and top screw from the mount to separate the mounting plate.
Step 3: Attach Mounting Plate
Attach the mounting plate to a wall stud or structural support using the provided screws. Ensure it is level.
Step 4: Align and Install
Align the mount with the mounting plate on the wall and reinstall the screws to secure it in place.
Step 5: Finalize Installation
Tighten all screws and reattach the plastic cover for a finished look.
Adjust Arm Range of Motion (Optional)
To limit the arm’s range of motion, position the stop ring at the desired angle. The arm can rotate freely if the stop ring is not used.
Mounting Monitor Arm
Insert the monitor arm into the mount until the release button locks it in place. To remove, press the release button and pull the arm up near the joint.
FAQ
- Q: Can I mount this product on drywall alone?
- A: Mounting to drywall alone is not recommended. It is advised to attach the mounting plate to a wall stud or structural support for stability.
- Q: How do I adjust the arm’s range of motion?
- A: Position the stop ring to limit the arm’s range of motion. The marked angle will be in the center of the range of motion. If not using the stop ring, the arm can rotate freely.
Installation
STEP 1:
Remove the plastic front cover.
STEP 2:
Remove the two side screws and top screw from the mount and Separate the mounting plate from the rest of the mount.
STEP 3:
Attach the mounting plate to a wall stud or other structural support using the screws provided. Mounting to drywall alone is not recommended. Use level to ensure that mounting plate is perfectly level.
STEP 4:
Align the mount with the mounting plate on the wall.
STEP 5:
Reinstall the two side screws and top screw into the mount and tighten.
STEP 6:
Reinstall the plastic cover.
STEP 7:
Position the stop ring to limit the arm’s range of motion if desired. The marked angle will be in the center of the range of motion.
STEP 8:
Insert the monitor arm into the mount until the release button locks in place.
To remove arm press the release button and pull the arm up near the joint.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>