Humanscale M2.1 Direct Wall Mount Instruction Manual
- June 1, 2024
- Humanscale
Table of Contents
Human scale M2.1 Direct Wall Mount
INSTALLATION INSTRUCTIONS
STEP 1:
Remove the plastic front cover.
STEP 2:
Remove the two side screws and top screw from the mount and Separate the
mounting plate from the rest of the mount.
STEP 3:
Attach the mounting plate to a wall stud or other structural support using the
screws provided. Mounting to drywall alone is not recommended. Use level to
ensure that mounting plate is perfectly level.
STEP 4:
Align the mount with the mounting plate on the wall.
STEP 5:
Reinstall the two side screws and top screw into the mount and tighten.
STEP 6:
Reinstall the plastic cover.
STEP 7:
Position the stop ring to limit the arm’s range of motion if desired. The
marked angle will be in the center of the range of motion.
STEP 8:
Insert monitor arm into the mount until release button locks in place. To
remove arm press release button and pull the arm up near the joint.
