Humanscale M81 Mounting Arm Instruction Manual
- June 1, 2024
- Humanscale
Table of Contents
Humanscale M81 Mounting Arm
MB.1 M10 SlatWall Mount
Installation Instructions
-
STEP 1:
Remove the plastic front cover. -
STEP2:
Adjust the spacing between hooks with the top screw to fit onto rail. Turn clockwise to tighten hooks and counter-clockwise to expand. -
STEP 3:
Turn both front screws counter-clockwise to loosen the top hook if needed to fit onto rail. -
STEP4:
Place the mount on rail and turn both front screws clockwise to secure the top hook. -
STEP 5:
Turn the top screw clockwise to secure the lower hook. -
STEP 6:
Reinstall the plastic cover. -
STEP 7:
Position the stop ring to limit the arm’s range of motion. The marked angle will be in the center of the range of motion. -
STEP 8:
Insert monitor arm into the mount until release button locks in place. To remove arm press release button and pull the arm up near the joint.
Note: If using a 3 link configuration, one of the links must be a 4″ link.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>