Humanscale NeatTech Under Desk Cable Instruction Manual
- October 30, 2023
- Humanscale
Table of Contents
NeatTech™ Under Desk Cable
Instruction Manual North America: +1 800 400 0625
Europe: +353 (0)1 858 0910
Asia Pacific: +8522581 0570
Tools Required
Phillips Head Screwdriver
Parts Included
Assembly Instructions
-
Referencing the dimensions below for your NeatTech size, transfer the hole pattern in the hooks to the desired location on the underside of the work surface. Install the hooks with the arrows pointing to the front of the desk. If using a work surface:
Less than .875” in thickness use the shorter screws (#10 x 5/8”) provided
Greater than .875” in thickness use the longer screws (#10 x 1”) provided
-
Once the hooks are installed, hang the basket with the plastic tabs at the bottom, as shown below. Ensure that the hook-and-loop fastening strips face the front of the desk.
-
Secure the power strips, cables and other peripherals within the basket using the hook-and-loop fastening strips.
WARNING: The installation/operating instructions of items placed within the basket must be followed. The fastening strips should not obstruct the insertion of plugs into any items with receptacles. Plugs and/or power adapters must be fully seated.
-
Once the cables are secured, lift the plastic tabs and secure them to the available hook to complete installation.
1114 6th Ave, 15th Floor
New York, NY 10036
humanscale.com
For our terms and conditions please go to
https://www.humanscale.com/about/legal-information/terms-conditions.cfm
© 2021 Humanscale Corporation. The text and artwork are copyrighted materials.
All rights reserved. The Humanscale mark and logo are trademarks of Humanscale
Corporation and are
registered in the United States and certain other countries. The Neat Tech
trademark is owned by Humanscale Corporation.
3/15/2022
GT -NPD-AI-1750-001-R00