Hunter 19924 Lenlock 2 Light Vanity Installation Guide
- July 9, 2024
- Hunter
Table of Contents
Hunter 19924 Lenlock 2 Light Vanity
- Here are the tools you’ll need to complete your installation:
- Ladder
- Screwdriver
- Pliers
- Wire Strippers
- Drill
OVERVIEW
INSTALLATION INSTRUCTIONS
WARNING
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.the ground wire for the installation ten stung no present, immediately STOP installation and consult a qualified electrician.
- All wiring must be per national and local electrical codes ANSI/NFPA 70. It you are unfamiliar with wiring or in doubt, consult a qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. They must be read carefully
and completely before beginning the installation of the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the wall, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Put the drywall anchor (F} inside the hole in the wall. Pull the house wires through the center of the mounting plate (A}. Secure the mounting plate (A} to the junction box by tightening the screws (B} then insert the drywall screw (G} through the mounting plate (A} into the drywall anchor (F}. For a vertical installation make sure the mounting plate (A} has the folded sides with drilled holes at the top and bottom of the junction box.
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach the fixture’s wires to the power supply wires from the junction box. Connect black to black (live}; white to white (neutral}; grounding to grounding (green or copper}. Twist the ends of the wire pairs together. Then, twist on a wire connector. Make sure all twists are in the same direction. Loop the fixture’s ground wire around the grounding screw (C} and tighten. If there is no ground wire (green or copper} from the junction box, contact a qualified electrician.
FINISHING THE INSTALLATION
Place the fixture (E} over the mounting plate (A} making sure to align the holes of the fixture with the holes of the mounting plate. Secure the fixture with screws (D}. Install the bulbs according to the fixture specifications (not included}. Do not exceed the recommended wattage. Lift the glass (H} and align the notches in the glass with the tabs in the lamp cup (E}. Attach the glass by lifting and turning clockwise one-third of a full turn of the glass until it stops. Turn on the power and test the fixture. Your installation is now complete.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep
cleaning. For regular cleaning, turn off the light and wipe down the fixture
with a clean lint-free cotton or microfiber cloth. Never spray cleaner
directly onto the fixture.
NOTE
Drill 9/64″ pilot holes in the support structure to aid in securing the
light fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>