LOOWOKO L-WP-10L5 Magnetic Wireless Power Bank User Manual
- July 7, 2024
- Loowoko
Table of Contents
LOOWOKO L-WP-10L5 Magnetic Wireless Power Bank
Magnetic
Wireless Power Bank (L-WP-10L5)
Product Introduction
Thank you for choosing our Magnetic wireless Power Bank Please read over carefully and keep this manual for your records
Charging the device
- Connecting the Type-C interface of the Magnetic wireless Power Bank to the power adapter
- The Battery indicator glow white in charging mode
For a better charging experience, please use a power adapter above 20W
For a more accurate display of the power level, it is recommended to perform
two charge/discharge cycles.
Wireless Charging the phone
put the device on the middle of the phone back, it can be adsorbed automatically and charging the phone at the same time When using wireless charging, the wireless charging indicator is always on; after disconnecting from the phone, the wireless charging indicator flashes slowly for 10 seconds and then turns off; when the wireless charging area touches a metal foreign object, the wireless charging indicator flashes quickly.
Wired Charging the phone
Use the charging cable to connect the magnetic wireless power bank and your
phone 
Wireless applicable device
Devices built-in wireless charging receiver and support fast wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei P30
Pro/Mate30/Mate30 Pro/P40 Pro stand charger for Iphone XS Max/Xr/11/11 Pro/11
Pro Max and all Qi-enabled devices)
Magnetic charging equipment
Iphone 12/13/14/15 series and above models
Specifications
- Model No.: Capacity: L-WP-10L5
- Rated Capacity: Type-c 10000mAh/ 3.87V/38.7Wh
- Input: Type-c Output: 6000mAh (5V2A) 5V3A,9V2.2A, 12V1.67 A
- Wireless Output: 5V3A,9V2.2A, 12V1.67 A
- Transmission distance: 15W Max
- Charging efficiency: ≤3-6mm
- Size: 102mm x 70mm x 14.3mm
- Unit weight: ≥75%
- FCC ID: ZAYA9L-WP-10L5~1880 (NW)
Standard accessories
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>