Shenzhen Loowoko Technology L-WP-05A5 Magnetic Wireless Power Bank User Manual
- June 6, 2024
- Shenzhen Loowoko Technology
Table of Contents
Shenzhen Loowoko Technology L-WP-05A5 Magnetic Wireless Power Bank
Product Introduction
Thank you for choosing our Magnetic wireless Power Bank Please read over carefully and keep this manual for your records
Charging the device
- Connecting the Type-C interface of the Magnetic wireless Power Bank to the power adapter
- The Battery indicator glow white in charging mode , the wireless indicator lights up for 5S and then goes outFor a better charging experience, please use a power adapter above 20W
Wireless Charging the phone
put the device on the middle of the phone back, it can be adsorbed automatically and charging the phone at the same time, the wireless indicator glows blue
Wired Charging the phone
Use the charging cable to connect the magnetic wireless power bank and your phone
Wireless applicable device
Devices built-in wireless charging receiver and support fast wireless charging
(Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei P30
Pro/Mate30/Mate30 Pro/P40 Pro stand charger for Iphone XS Max/Xr/11/11 Pro/11
Pro Max and all Qi-enabled devices)
Magnetic charging equipment
(Iphone 12mini/12/12Pro/12Pro Max)
Specifications
-
Model No.
L-WP-05A5 -
Capacity:
5000mAh/3.85V/19.25Wh -
Type-C Input:
5V3A,9V2.2A,12V1.67A -
Type-C Output:
5V2.4A,9V1.1A,12V1.0A -
Wireless Output:
5W，7.5W，
Type-c and wireless charger output are not supported at the same time
Standard accessories
FCC ID：2AYA9L-WP-05A5
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits a redesigned to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is subject to the
following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment shall be installed and operated with
minimum distance 20cm between the radiator & body.