SmallRig Encore PT60 Windproof Live Broadcast Stabilizer Stand Instruction Manual

Table of Contents

Specifications:

Specifications subject to change without prior notice. Please refer to the physical product for the most up-to-date information.

Operating Instruction

In the Box

Product Details

Operating instructions for stand:

Pan and Tilt Lock: Loosen the knob to adjust the angle up and down. Tighten the knob after completing the angle adjustment.
Locking Knob: Extend the four legs outward. Hold the sleeve and pull it down to the bottom to extend the legs to their maximum angle. Then, place it on a flat surface. Be careful not to pinch your fingers when folding the legs.
Telescopic Pole: Extend the telescopic pole to the desired height.
Phone Clamp: Expand the phone clamp, place the phone inside, and clamp it.

Remote Control Operation Instructions:

Disassembly: Use your fingers to grip the top of the remote control and gently pull it outward
Installation: Align the remote control with the storage slot and press inward.
Shutter Button: Short press for 1 second to take photos and record videos, long press for 3 seconds to power on/off.
Connection Pairing: A slow flashing of the indicator light after powering on indicates entering pairing mode. Open the Bluetooth settings on your phone and search for the remote control named SmallRig PT60 to pair.

Ground Spike Usage Instructions:

Extend and Rotate: Extend the legs and rotate the ground spike counterclockwise to remove it.
Installation: Flip the ground spike over and rotate its head clockwise into the ground spike compartment.
Surface Usage: After installation, it can be inserted into soft surfaces such as grass or sand, but should not be used on concrete or rocky surfaces.

Operating instructions for stand

Lift the handle upward to unlock it, which allows the phone clamp to rotate 360°. Press downward to lock the handle.
Loosen the knob to adjust the angle up and down. Tighten the knob after completing the angle adjustment.
Extend the four legs outward.
Hold the sleeve and pull it down to the bottom to extend the legs to their maximum angle. Then, place it on a flat surface.
Extend the telescopic pole to the desired height.
Expand the phone clamp, place the phone inside, and clamp it.

Remote Control Operation Instructions

Disassembly: Use your fingers to grip the top of the remote control and gently pull it outward.
Installation: Align the remote control with the storage slot and press inward.
Shutter button: Short press for 1 second to take photos and record videos, long press for 3 seconds to power on/off. The indicator light will flash quickly 3 times when powering on/off.
Connection pairing: A slow flashing of the indicator light after powering on indicates entering pairing mode. Open the Bluetooth settings on your phone and search for the remote control named “SmallRig PT60” to pair. Once successfully connected, the indicator light will stop flashing.

Remote Control Operation Instructions

Extend the legs and rotate the ground spike counterclockwise to remove it.
Flip the ground spike over and rotate its head clockwise into the ground spike compartment. After installation, it can be inserted into soft surfaces such as grass or sand, but should not be used on concrete or rocky surfaces.

GB 4943.1-2022
FCC ID: 2BC2U-PT60
LQ-B275-18
Made in China

Q: Can I adjust the angle of the stand?
A: Yes, you can adjust the angle using the Pan and Tilt Lock feature by loosening the knob, adjusting the angle, and then tightening the knob.
Q: How do I pair the remote control with my phone?
A: To pair the remote control, ensure it is in pairing mode (indicated by a slow flashing light), then open your phone’s Bluetooth settings and search for SmallRig PT60 to connect.
Q: What is the maximum phone clamp capacity?
A: The phone clamp can accommodate phones with widths ranging from 2.6 inches to 3.8 inches (65.0mm to 97.0mm).