dormakaba SL30 Mini Electronic Side Load Lock User Guide
- July 5, 2024
- dormakaba
Table of Contents
dormakaba SL30 Mini Electronic Side Load Lock
- Wiring the lock requires at least three connections; red (positive), black (negative), and blue (control).
- Ensure the power supply has the following current available to power the lock when supplied with the following; 400mA for 24VDC supply and 750mA for 12VDC supply.
- Use an appropriate wire gauge for the wire run distance between the lock and power supply.
- Do not mount the lock in the floor operating upwards or in an environment where it can get wet
Warranty Information
The product is covered by a 3-year manufacturers’ warranty against faulty or
malfunctioning parts, components, or product. A faulty product can be returned
at the customers’ expense to the seller for review. At the seller’s
discretion, either a replacement lock or affected part will be supplied to
remedy the fault. Removing the lock cover or faceplate screws may void the
warranty.
Mistreatment or ill-use of the lock may void the warranty.
Package Contents
Lock
Strike Plate
Wiring loom
4x mounting screws
Product Dimensions
Wiring Gauge Table
| Conductor Cross Sectional Area | Ma:omum Distance |
|---|---|
| MWG | (mm’) |
| 24 | 0.20 |
| 22 | 0.33 |
| 20 | 0.52 |
| 18 | 0.82 |
| 16 | 1.31 |
| 14 | 2.08 |
Wiring IO Table
| Wire Colour | Meaning | Description |
|---|---|---|
| RED | Power Supply (12 – 24VDC) | Positive connection to DC power supply, ·+ |
| BLACK | Negative connection lo DC power supply, • -• | |
| BLUE | Control | SWitched positive control input |
| VIOLET | Bolt Position Monitor | Normally open contact {NO), closed when the |
bolt pin is extended (optional)
VIOLET
WHITE| Door Position Monitor| Normally open contact {NO), closed When the
strike is aligned with the lock (optional)
WHITE
How to wire the lock for each operating mode
Fail Safe Wiring, control high to lock.
Fail Secure Wiring, control low to lock.
How to set the operating mode
Toggle the switch on the product before powering up
Wooden Door Frame Mortice Example SL30 SGL
The dimensioned drawing is an example of how to cut the mortice for the lock into a timber door frame. This should be centered with the centre of the door leaf when closed.
Cut any additional pathways. required for the wiring loom.
Ensure the lock is orientated such that the bolt pin pulls the door in towards the door jamb.
Pull wiring through and connect to the lock. then fit lock into mortice and secure with included mounting screws.
Repeat process for strike plate allowing room behind bolt pin hole.
Customer Support
Any questions? We would be happy to advise you.
Contact us at: 01462 477600
dormakaba UK & Ireland | Wilbury Way | Hitchin |
info.gb@dormakaba.com | dormakaba.com/gb-en
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>