THE DRIVESHAFT SHOP 2010 plus Camaro G8 CTS-V One Piece Driveshaft Owner’s Manual
- July 5, 2024
- THE DRIVESHAFT SHOP
Table of Contents
THE DRIVESHAFT SHOP 2010 plus Camaro G8 CTS-V One Piece Driveshaft
Product Information
Our driveshafts have been designed with the highest quality standards in mind for maximum performance. We have manufactured and precision balanced each shaft to allow your vehicle to transfer more power to the ground. This driveshaft is intended for high performance applications where vehicle performance and safety are top priorities. Please note that you are converting from an OE two-piece driveshaft design to an aftermarket High Performance one- piece design. With this change and other performance driveline & suspension components that need to be installed in tandem will impact overall NVH (Noise, Vibration, Harshness) during certain operating conditions. To minimize the effects of NVH we recommend you start by rotating the driveshaft 180 degrees and bolting your driveshaft into its new position. To find the optimal operating position it is possible that you will need to make small adjustments and evaluate performance during this process. For more information on this refer to our Vibration Check list located in the support section of our website.
Specifications:
- Designed for high-performance applications
- One-piece driveshaft design
- Precision balanced for maximum power transfer
- Impact on NVH during certain operating conditions
- Compatibility: 2010+ CAMARO/G8/CTS-V
Product Usage Instructions
EXTREMELY IMPORTANT: NOT CHECKING MEASUREMENTS WILL VOID THE WARRANTY
Installation:
- Ensure you are converting from an OE two-piece driveshaft to the new one-piece design.
- Rotate the driveshaft 180 degrees before bolting it into place.
- Check and adjust the driveshaft position for optimal performance and NVH reduction.
- Refer to the Vibration Check list on the manufacturer’s website for more guidance.
Driveshaft CV Clearance Check:
After installation, ensure the driveshaft CV clearance is within the allowed
range. Driveshaft CV Clearance MUST BE CHECKED after installation. This
measurement must be between 3.25” – 3.75” If dimension is not within the
allowed range, do not run the driveshaft.
Adapter Plate Hardware Torque:
- Front (All): (3) M12 Bolts – 70 ft-lbs / (6) M10 Bolts – 57 ft-lbs
- Rear (Stock Differential): (3) M12 Bolts – 70 ft-lbs / (4) 3/8 Bolts – 54 ft-lbs
FAQ
-
Q: What should I do if the Driveshaft CV Clearance is not within the allowed range?
A: If the dimension is not correct, do not run the driveshaft. Contact customer support for assistance. -
Q: How do I know if my vehicle is compatible with this one-piece driveshaft?
A: This driveshaft is intended for high-performance applications in 2010+ CAMARO/G8/CTS-V models. Ensure compatibility before installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>