Youshifa FBMINIFSPK Wireless Mini Fabric Speaker User Manual
- July 4, 2024
- Youshifa
Table of Contents
Youshifa FBMINIFSPK Wireless Mini Fabric Speaker
WHAT’S INCLUDED
- FBMINIFSPK Wireless Speaker
- Type-C Charging Cable
- User’s Manual with Warranty Information
Charging :
Insert need of the included Type-C charging cable (included) into The DC 5V
charging port on yours Peaker.
Insert the other end into the USB port of a computer or suitable USB charging
adapter.
When in Charging (Indicator is in Red )
When Charging Complete (Indicator is Off)
Power On
Slide the power switch to the ON position to power ON the speaker.
After powering ON, the speaker will automatically going to Bluetooth pairing
mode.
Slide the power switch to the OFF position to power the speaker OFF.
Remark: The speaker will turn off automatically after 10 minutes standby.
Bluetooth Pairing
Power on your speaker. The speaker will automatically in bluetooth mode. Then
go to the Bluetooth settings menu on your phone.
Make sure that Bluetooth is turned on. Connect to the device listed as “mini
speaker”
TWS Function
If you have two FBMINIFSPK speakers, enjoy high-quality sound By using the TWS pairing function.
Power on both speakers, the two speakers will pair with each other automatically , once paired successfully a tone will be heard .
You can then go to the Bluetooth settings menu on your phone.
Make sure that Bluetooth is turned on.
Connect to the device listed as “mini speaker”
Specifications
Bluetooth Version: V3.0
Bluetooth Range: Up to 33 feet (10 meters)
Power Supply: DC 5V,1A (USB)
Battery Type : 3.7V 400mah Battery
Play Time (Only Music) : 2-3hours
*Applicable at 50% of maximum volume. Results will be lower when volume is higher.
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure requirement set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>