Mouses HYL-16 Vertical Mouse Instruction Manual
- June 6, 2024
- Mouses
Table of Contents
Mouses HYL-16 Vertical Mouse
Vertical mouse instruction manual
This ergonomic vertical mouse combines the state of the human hand when placed naturally ,it can effectively prevent the mousehand ,relieve fatigue, reduce the burden onthe arm and shoul derpain, which makes wor k more relax.
OVERVIEW
Parameters
- Size:1226275mm
- weight:140 g
- engine:wired laser
- wireless,photoelectic
- Number of keys:6
- Resolution:wired:800-1200-200-3200
- wireless:800-1200-1600
- System support: windows series MAC Linux
- Power supply:wired,5V 1.5m USB cable
Connected to use
Wired mouse: lnsert the USB into the device interface, without any driver,if the cursor is floating,the cause of the cursor floating is the surface of the mouse moving usually, You’d better replace a high-quality mouse pad,Wireless mouse; take out the USB receiver,and correctly insert it into the device which supports the use of USB, open the switch at the bottom of the receiver,the mouse will automatically create a connection with the recover,then you can use the mouse normally.You can close the switch if you do not use the mouse.This mouse supports secondary sleeping mode,which can save power,lf you do not wse it for a long time it will automatically sleep.and you can press any mowse button to wake up.
Rechargeable Battery
The power supply of the wireless is the built-in lithium battery, when the
mouse can not be used in the machine or when the cursor is not smooth or
difficult to move, then need to charge the battery, the charge can use the
manufacturer equipped with USB charging line charge. You can wse Andrews phone
charging line to charge conveniently.The wireless mouse is charging during the
charging light is red, when the charging light turns into a green.you can
remo.
Warning :This wireless mouse has a battery,do not disassemble,do not put
in the fire or high temperature and high heat environment, to prevent the
explosion.
FCC STATMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
oF the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement.