FreeSUB ST-4050 Sublimation Heat Press User Manual

: July 3, 2024
: Freesub

Table of Contents

FreeSUB ST-4050 Sublimation Heat Press
Product Usage Instructions
Frequently Asked Questions
Unpacking
Feature Commentary
Function Commentary cf Combination Key
Pressure regulation explanation
Accessory Name Graphic
Circuit Board Wiring Method
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FreeSUB ST-4050 Sublimation Heat Press

Product Specifications

Model: ST-4050
Voltage: 230V 50Hz / 110V 60Hz
Transfer Size: 400x500mm
Max Pressure: 700KG
Pressure Adjustment: 0-90% with nine levels
Power: 1400W
Weight: 23KG
Packing Size: 810x520x485 mm

Product Usage Instructions

Unpacking

Please carefully remove the packing foam and store it for maintenance purposes.

Feature Commentary

The machine features an emergency stop switch, pressure adjustment for the hydraulic pump, mode setting, time setting, and value adjustment buttons.

Gross Statistics Setting

To set gross statistics, press the + button for three seconds, then press and hold the – button. Release the buttons, then press + and – to adjust the settings.

Accessory Name and Circuit Board Wiring

The machine comes with various accessories including a handle, suction cup, lifting lever, up-heating board, silicone pad, pull and push handle, suction foot, slide guide, hydraulic pump, hand cover, electromagnet, and circuit board.
Refer to the circuit board wiring method for proper installation.

Frequently Asked Questions

Q: How do I adjust the pressure for different materials?

A: Adjust the pressure screw to easily press based on the material being used. The 5th level is recommended for sublimation crystal and rock photos to avoid product fracturing.

Q: What should I do in case of an emergency?

A: Press the emergency stop switch (STOP button) to release the handle and handle any emergencies.

warnings must be followed carefully to avoid bodily injury.

Unpacking

Contents may vary by location
Please remove the packing foam carefully and keep it well for maintenance.

Main technical parameters of ST-4050

Feature Commentary

Emergency stop switch.
Press this button in an emergency, and up heating board will up.
Can be used as a start button when in manual operation.
Adjust hydraulic pump pressure.
0-9% a total of nine levels, adjust the pressure you need.
Set input button Press to set temperature.
Press again to set the time.
Value plus.
Can be used as a leftwards button when choosing the save parameter setting.
value minus.
Can be used as a rightwards button when choosing the save parameter setting.
Use “+ “and “-“to switch the six parameters save settings.

Processing capacity setting
- Press **” for three seconds, hear one beep, and keep pressing. Then press “-“, after hearing one beep, you can set the Release button, and press “+” and “-” to set the amount.
Gross statistics
- Press “-” for three seconds, hear one beep, and keep pressing. Then press “+”, and after hearing one beep, you can see the gross statistics from the factory default to now.

Function Commentary cf Combination Key

Attention: Press ( + / -) at the same time, you can switch between oF &°C.

Keys function explanation

Pressure regulation explanation

Set the pressure to 0 level.
Put the product on the flatbed
Adjust the pressure screw to be able to easily press, the screw will pop up when press the red button.
As shown in the picture, move to the 6th level, handle down, press the emergency stop switch (STOP button), and the handle will be able to pop up.
- Note 1: Adjust the 5th level when sublimation crystal and rock photo, to avoid product fracturing.