YAMAN YJFM24V Generation Multifunctional Beauty Device User Manual
- July 6, 2024
- YAMAN
Table of Contents
- YAMAN YJFM24V Generation Multifunctional Beauty Device
- Product Information
- Product Usage Instructions
- Safety Precautions
- When Using Outside of Japan
- Names of Components
- Accessories
- Before Use
- How to Read the Panel
- Frequently Asked Questions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
YAMAN YJFM24V Generation Multifunctional Beauty Device
Product Information
Specifications:
- Charging Time: Approx. 3 hours
- Operating Time: Approx. 30 minutes
- Level Indicator: 5 levels
Product Usage Instructions
Charging the Battery:
To avoid shock, short circuit, fire, or device malfunction, follow these steps:
- Insert the AC adapter plug into the adapter socket of the main unit.
- Allow the battery to charge for approximately 3 hours.
- After charging is completed, disconnect the AC adapter plug from the wall socket and then from the device.
*The actual charging time may vary based on the remaining battery level and charging environment.
How to Read the Panel:
- Level Indicator (5 levels)
- MODE Indicator
- Bluetooth Indicator
- Charging Indicator
- CUSTOMIZE Button
- LEVEL Button
- POWER/MODE Button
Safety Precautions
- Read these Safety Precautions carefully before using the device in order to use it correctly.
- Use the device sensibly in accordance with the prescribed steps.
- Immediately discontinue use and arrange to have the device repaired if any abnormality occurs.
- Do not use the device in a defective state, as doing so could cause a physical harm to the user.
- The precautions listed in the User’s Manual are very important. For your safety, please follow them carefully.
- Precautions are classified as DANGER, WARNING, or ATTENTION in order to clearly specify the level of danger and possible injury or damage that may occur if the device is misused.
Classifications of Precautions
DANGER| Improper use of this device poses a severe and likely risk of death or
serious injury.
---|---
WARNING| Improper use of this device may pose a risk of death or serious
injury.
ATTENTION| Improper use of this device may result in injury or property
damage.*
- “Property damage” refers to damage affecting a dwelling, household belongings, or domestic animals and pets.
DANGER
The following individuals should not use the device:
- Use of the device could cause electronic medical devices to malfunction.
- Do not use the device in conjunction with any medical electronic equipment, including:
- Pacemakers or other implanted electronic medical devices;
- Artificial heart-lung machines or other electronic life-support medical devices; and
- Electrocardiographs or other worn electronic medical devices.
WARNING
- Do not use under the following conditions:
- If you have existing or suspected epilepsy, heart disease, or related disorders
- If you are unable to sense temperature or stimulation
- If you have an autoimmune disease
- Infants or those who are unable to express their intentions on their own
- Consult a physician prior to use under the following conditions:
- If you have an acute disease
- If you have an infectious disease
- If you have a malignant tumor
- If you have a fever
- If you have high blood pressure or a blood disease
- If you have sensory impairment due to severe peripheral circulatory dysfunction (e.g. diabetes)
- If you have a nerve damage
- If you have a skin disease or atopic dermatitis
- If you are a hospital outpatient and are taking medication
- If you have a pre-existing skin condition, such as an allergic constitution or contact dermatitis, or if you have a concern about your skin when using this device
- Do not use in the following cases or on the following areas:
- If your skin is damaged, experiencing a rash, inflammation, or other abnormalities
- If you are under the influence of alcohol
- Anywhere inside the mouth, around the pubic region, or any mucous membrane
- Eyeballs
- Upper eyelids (except in COOL Mode, but can be treated with the LED light)
- Lower eyelids and outer corners of the eyes (except in EYE CARE Mode and COOL Mode, but can be treated with the LED light)
- Throat
- Head
- Bulging moles
- Viral warts
- Areas where you have broken a bone
- Areas of internal bleeding, swelling or scabbing after cosmetic medical procedures
- Avoid using the device for 2 weeks after cosmetic medical procedures. After this period, consult with a physician and only use the device if the physician confirms there is no problem (e.g., Hyaluronic acid injections, silicone injections, botox, thread lifts, double eyelid surgery, HIFU, etc.)
- Areas where metal was implanted by surgery (reconstructive surgery, plastic surgery, cosmetic surgery, etc.)
- Do not use the device for a long time over areas where the skin is thin or areas above bones. Failure to comply may cause skin problems or physical ailments.
- Do not overuse the device. Follow usage time and frequency, follow the instructions in the User’s Manual. Failure to comply may cause physical injuries.
- Before use, check to make sure the electrode and treatment head are not cracked, deformed or broken. Do not use the device if it is damaged or malfunctioning. Failure to comply may cause injuries or skin problems.
WARNING
- Do not use, store or charge the device in the following locations:
- In bathrooms or near bathtubs, showers, washbasins or other containers filled with water
- A dusty location, a location where there is exposure to direct sunlight or outdoors
- Uneven or unstable location, or a location where there is vibration or shocks
- A location where there are strong radio waves or magnetism
- Near a flammable substance (such as alcohol, thinner, benzene, nail polish remover or spray)
- A location where there is exposure to oil smoke or steam
- A location that may become hot, such as near a heating device (e.g. a heater)
- A location with drastic temperature changes (for example, near an air conditioner or heater)
- Do not use the device if the AC adapter is damaged. Use a dedicated AC adapter.
- Do not pull the plug from a power outlet or pull the plug from the main unit during use. Failure to comply may cause an electric shock or a fire due to a short circuit. Be sure to turn off the power before pulling out the plug.
- Do not use the device for any purpose or in areas other than those stated in the User’s Manual. Failure to comply may cause a malfunction of the device or injuries.
- Children should obtain the consent of their guardians before using the device and should only use it under the supervision of a guardian or specialist. Failure to comply may cause an accident or an injury.
- Do not use at a temperature below the specified ambient temperature. Failure to comply may cause the electrodes to stick to and damage the skin.
- Do not leave the device unattended while it is turned on. Failure to comply may cause a fire or accident.
- Keep the device and AC adapter away from children and do not allow them to use it alone. Do not allow children to play with the device. Failure to comply may cause an accident or injury.
- Do not dispose of the device in a fire or place it near fire or flames. Do not use, charge or store in a high-temperature or high-pressure area. The device features a built-in rechargeable battery. Failure to comply may lead to the generation of heat, a fire or explosion.
- Do not connect too many plugs to one outlet exceeding the rated capacity of the outlet. Failure to comply may cause an electric shock, short circuit, fire, or malfunction of the device.
- Do not use the AC adapter if it is damaged or if the wall socket is too loose. Failure to comply may cause an electric shock, short circuit, fire, or malfunction of the device. Contact your local distributor for advice on repairing the device.
- Be sure to use the device in an operating voltage range between 100-240 volts. Make sure the plug is fully inserted into the power outlet. Failure to comply may cause a fire, an electric shock, or other accidents. * The free-repair warranty is only valid in Japan.
CAUTION
- Do not press the device strongly or use it intensively on a single area. Pressing the device stronger than necessary or using it intensively on a single area may damage the skin.
- Do not use while driving. Failure to comply may cause accidents or injuries.
- Do not use COOL Mode continuously. If used for continuous treatments, the head will not fully cool. Have an interval of at least 30 minutes between treatments.
- Use only Level 1 upon the first use and until you are accustomed to use. Even if you do not feel any stimulation, make only small adjustments to the intensity level. Use the device at an intensity level that suits you. Make only gradual adjustments to the intensity level. Failure to comply may cause an accident or an injury.
- Do not allow the device to come into contact with another beauty device or electronic appliance while the power is on. Do not use with other electronic products (electric blankets/bed sheets, heated tables, etc.) at the same time. Failure to comply may lead to accidents due to malfunctions.
- Do not expose the device to strong water pressure from showers or faucets nor submerge it in water. Though the water resistance rating of the device is JIS protection grade IPX5, it is only protected against dripping water according to the product specifications. Do not intentionally splash water on the device because it is not designed to withstand strong water pressure from showers or faucets, nor to be submerged in water. Failure to comply may cause a malfunction of the device.
- Do not look directly into the LED light. When using the LED light to treat areas around the upper eyelids, lower eyelids or outer corner of the eye, be sure to close your eyes and keep the electrode head at least 5 cm away from your skin. Failure to comply may cause damage to your eyes or skin.
- Avoid using the device on the same area for longer than 15 minutes. When using on the same area again, be sure to leave an interval of 24 hours or more between treatments. Excessive use may damage the skin. The above recommendations are merely guidelines. Please observe your skin condition and use the device accordingly.
- If you are currently undergoing dental treatment or have teeth fillings, choose a lower intensity level and apply the device on a different area. You may feel strong irritation or discomfort due to the EMS on your cheeks or chin. If you feel strong discomfort, consult a physician.
- During the treatment, carefully check that your skin is not showing any abnormalities. Stop using the device immediately if you start to feel pain, fatigue or if you see any skin reaction during use. Stop using the device immediately if the treatment does not agree with your skin. If symptoms persist the following day and beyond, consult a physician.
- If a power failure occurs, turn off the power immediately and unplug the device from the power outlet. Failure to comply may cause an accident.
When Using Outside of Japan
WARNING
- Use the device at AC100-240V only (free warranty service is only available in Japan). Failure to comply may cause a fire, electric shock or a failure of the device.
- Be sure to check the plug configuration and the voltage of the power outlet before use. Failure to comply may cause the generation of heat, a fire, or a malfunction of the device.
The plug configuration and voltage may vary depending on the region and the type of accommodation. Always be sure to check for compatibility before using the device. For information about plug adapters, consult a consumer electronics retailer.
Names of Components
Main Unit
- LED Lamps
- Electrode head
- Indicator
- CUSTOMIZE Button
- LEVEL Button
- POWER/MODE Button
- Adapter plug insertion port
Accessories
- Cotton Stopper
- The cotton stopper is attached to the electrode head when purchased.
- Use this stopper to fix cotton pad to the electrode head.
- AC adapter
- The design and specifications of the device and accessories are subject to change for improvements without prior notice.
Before Use
Charging the Battery
This product is rechargeable and can be used either without an electric cord or by connecting it to an AC adapter. Always use the device after charging when you use the device without an electrical cord.
- Before using for the first time, or if you have not used the device for an extended period, fully charge the battery and make sure that the charging indicator has turned from flashing to solid, indicating a full charge.
- Make sure that there is no water on the adapter plug insertion port. Failure to comply may cause an electric shock, short circuit, fire, or malfunction of the device.
Estimated Charging Time
Charging time | Approx. 3 hours |
---|---|
Operating time | Approx. 30 minutes |
- Charging at room temperature of approx. 25°C.
- Operating time when fully charged.
- Operating time may vary depending on the operating mode, operating level and/or operating environment.
- The actual charging time will differ depending upon the remaining battery and the charging environment.
Charging the Battery
- Insert the AC adapter plug into the adapter socket of the main unit.
- Plug the AC adapter into the power outlet.
- Use only the supplied exclusive AC adapter with this device.
- Plug the AC adapter directly into the wall socket. Do not overload the electric circuit.
- When charging begins, the charging indicator will flash. When charging has completed, the charging indicator will turn solid.
- After charging is completed, disconnect the AC adapter plug from the wall socket, then disconnect the adapter plug from the device.
How to Read the Panel
Indicator and Buttons
- Level Indicator (5 levels)
- Bluetooth Indicator
- Charging Indicator
- CUSTOMIZE Button
- LEVEL Button
- POWER/MODE Button
Frequently Asked Questions
- Q: How long does it take to charge the battery?
- A: The estimated charging time is approximately 3 hours.
- Q: How long can I use the device on a single charge?
- A: The operating time is approximately 30 minutes.
- Q: What should I do after charging is completed?
- A: Disconnect the AC adapter plug from the wall socket and then from the device.