HOFTRONIC BK02 LED Floodlight Sensor User Manual

HOFTRONIC BK02 LED Floodlight Sensor

IMPORTANT SAFETY DETAILS

1. Ensure the AC/Mains power is NOT connected and cannot be unexpectedly reconnected during installation.
2. This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical and safety regulations relevant to the country it is being installed.
3. This product may NOT be installed by minors or people with a mental disability.
4. Carefully observe all instructions of warnings that are labelled on, or supplied with your product.
5. This product is suitable for outdoor use. If in any doubt, consult a qualified electrician.
6. Please use proper wire for connection. The lenght of output leads should be typically 0.5m-2m in order to keep radio interference minimum.

DIAGRAM

SPECIFICATIONS

404x338x54mm
Color temp| 4000K/6400K
Work temp| -20°C – +50°C
Protection| IP65
Housing color| Black

TESTING PIR

• Turn the SENS dial clockwise to the maximum point, turn the TIME dial anti-clockwise to the minimum point, turn the LUX dial clockwise to the Sun.
• When you switch on the power, the fitting will not illuminate. After a 30 second pre-heat, when the sensor gets the induction signal, the load will turn on. Once the load switches off , it will then turn on again after 5-15 seconds of the sensor receiving an induction signal.
• After the sensor goes off, trigger the detection field after 5-10 seconds. The load should work.
• When there is no induction signals in the sensor, the load should stop working.
• Turn the LUX dial anti-clockwise to the Moon. If it is adjusted to less than 3 LUX (dark), the load and sensor should not work when testing in daylight. If you cover the detection window with an opaque object, the load should work.
• Under no induction signal condition, the load should stop working within 5-15 seconds.

NOTE: WHEN TESTING IN DAYLIGHT, PLEASE TURN THE LUX DIAL TO THE (SUN) POSITION, OTHERWISE THE SENSOR WILL NOT WORK!

ADJUSTABLE MOTION SENSOR

The motion sensor on this wide-angle light is fully adjustable for three values, namely: delay time, motion detection speed and ambient light:

• Delay time: This sets the amount of time it takes for the lamp to switch off after detecting movement. This is adjustable from 10 seconds to 2 minutes
• Detection speed of movement: Of course, you don’t want your wide-angle lamp to switch on with every movement. That is why you can set the minimum movement speed on the lamp. The speed can be set between 0.6 and 1.5 metres per second.
• Ambient light: Naturally, you only want the floodlight to switch on when it is dark outside. How dark it should be is up to you with the ambient light setting. This can be set to a value between 3 and 2000 Lux. At 2000 Lux the floodlight will almost ignore the ambient light. At 3 lux, the floodlight only switches on when it is really dark outside.

INSTALLATION

Install the LED floodlights on the ground, wall or ceiling.

This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your local authority or retailer for recycling advise. (Waste Electrical and Electronic Equipment Directive)

INTENDED USE / APPLICATION

Product designed for the use in households and for other similar general applications.

MOUNTING

Technical changes reserved. Read the manual before mounting. Mounting should be performed by an appropriately qualified person. Any activities to be done with disconnected power supply. Exercise particular caution. Product has a protective contact/terminal. Failure to connect the protective lead may lead to electric shock.
Mounting diagram: see pictures. Check for proper mechanical fastening and connection to electrical power prior to first use. The product can be connected to a supply network which meets energy quality standards as prescribed by law. To maintain the proper IP protection level, the right diameter of the power cable should be selected for the cable gland used in the product.

FUNCTIONAL CHARACTERISTICS

The product can be used indoors and outdoors.

USAGE GUIDELINES / MAINTENANCE

Any maintenance work must be performed when the power supply is cut off and the product has cooled down. Clean only with soft and dry cloths. Do not use chemical detergents. Do not cover the product. Ensure free air access. Product may heat up to a higher temperature. Product can only be supplied by rated voltage or voltage within the range provided. It’s forbidden to use the product with damaged protective cover. Product must not be used in unfavourable conditions, e.g. dust, water, moisture, vibrations, explosive air atmosphere, fumes, or chemical fumes, etc. Non- demountable product. Not suitable for independent repairs.

ENVIRONMENTAL PROTECTION

Keep your environment clean. Segregation of post-packaging waste is recommended. This labelling indicates the requirement to selectively collect waste electronic and electrical equipment. Products labelled in this way must not be disposed of in the same way as other waste under the threat of a fine. These products may be harmful to the natural environment and health, and require a special form of recycling/ neutralising. Products labelled in this way should be returned to a collection facility for waste electrical and electronic goods. Information on collection centres is provided by local authorities or sellers of such goods. Used items can also be returned to the seller when new product is purchased, in quantity no larger than the purchased item of the same type. The above rules regard the EU area. In the case of other countries, regulations in force in a given country must be applied. Contacting the distributor of our products in a given area is recommended.

COMMENTS / GUIDELINES
Failure to follow these instructions may result in e.g. fire, burns, electrical shock, physical injury and other material and non-material damage. For more information about Hoftronic products visit www.hoftronic.com. Hoftronic shall not be responsible for any damage resulting from the failure to follow these instructions. Hoftronic reserves the right to make changes in the manual – the current version can be downloaded at www.hoftronic.com.

References

• HOFTRONIC - HOFTRONIC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>