Barkbusters Benelli TRK502 Aluminum Handguard Kit Instructions
- June 3, 2024
- Barkbusters
Table of Contents
Barkbusters Benelli TRK502 Aluminum Handguard
Preparation
Remove original handguards if fitted.
RIGHT SIDE
RIGHT SIDE
Installation for Right Side
Repeat for Left side with applicable parts
- Loosely assemble the clamp to the handlebar as per diagram making sure to use the OEM bar end weight.
- Attach the handguard backbone (1) with applicable parts to the handlebar end and also to the clamp connector (6).
- Position backbone so it is horizontal when viewed from the side.
- Tighten all bolts in the following order: (10), (9), (4) then (7).
Important: Use the specified torque setting over page.
Bar Side View
SPARE PARTS
Recommended Torque Settings
M6| 10 Nm (7.4 lbf ft)
M8| 20 Nm (14.8 lbf ft)
Personalize Your Protection
CAUTION:
Installation of the handguard is safety-relevant work and can be complicated. We recommend the installation be performed by a motorcycle service technician. Rideworx accepts no liability for damages caused by improper mounting. All screws, bolts and nuts, including all replacement hardware provided by Rideworx, should be tightened to the torque specified in the table. After the first 50km of riding check all screws, bolts and nuts are tightened to the correct torque. We recommend a medium strength liquid thread lock product on all fasteners.
WARNING:
It is important there is a working clearance (approx 3mm) between the throttle grip end and the handguard to ensure a free closing throttle. Check the operation of all handlebar controls, specifically the throttle, front brake, kill switch and clutch to ensure they are operating correctly and are in accordance with the OEM specifications. Do not ride the motorcycle if any controls are not operating correctly. Check periodically that all bolts are tight. Please note that all Rideworx test fitment are done on stock motorcycles with factory standard handle bar, windscreen, etc. and in there original positions.
Disclaimer:
A failure to follow these fitting instructions could cause serious injury,
death or property damage. These handguards are intended solely for use with
motorcycles/ATV/snowmobiles/scooters that have not been modified. They are not
designed to prevent injury or death while riding or in an accident or crash.
The user must ensure that all controls are free of the handguards every time
that they ride. By installing and/or using this product you acknowledge that
you accept these terms and have followed the fitting instructions
INS-BHG-103-00-NP
www.barkbusters.net
Email: info@barkbusters.net
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>