Barkbusters Royal Enfield Scram 411 Instruction Manual
- June 3, 2024
- Barkbusters
Table of Contents
Barkbusters Royal Enfield Scram 411 Instruction Manual
Preparation
Remove original hand guards and bar end weights if fitted.
RIGHT SIDE
RIGHT SIDE
Installation for Right Side
Repeat for Left side with applicable parts.
- Loosely assemble the clamp to the handlebar as per diagram making sure to use the OEM bar end weight.
- Attach the handguard backbone (1) with applicable parts to the handlebar end and also to the clamp connector (4).
- Position backbone so it is horizontal when viewed from the side.
- Tighten all bolts in the following order: (9), (8), (3) then (6).
Important: Use the specified torque setting over page.
Bar Side View
Package Content
Recommended Torque Settings
M6| 10 Nm (7.4 lbf ft)
M8| 20 Nm (14.8 lbf ft)
Personalise Your Protection
Guard options sold separately
CAUTION:
Installation of the handguard is safety-relevant work and can be complicated.
We recommend the installation be performed by a motorcycle service technician.
Rideworx accepts no liability for damages caused by improper mounting. All
screws, bolts and nuts, including all replacement hardware provided by
Rideworx, should be tightened to the torque specified in the table. After the
first 50km of riding check all screws, bolts and nuts are tightened to the
correct torque. We recommend a medium strength liquid thread lock product on
all fasteners.
WARNING:
It is important there is a working clearance (approx 3mm) between the throttle
grip end and the handguard to ensure a free closing throttle. Check operation
of all handlebar controls, specifically the throttle, front brake, kill switch
and clutch to ensure they are operating correctly and are in accordance with
the OEM specifications. Do not ride the motorcycle if any controls are not
operating correctly. Check periodically that all bolts are tight. Please note
that all Rideworx test fitment are done on stock motorcycles with factory
standard handle bar, windscreen, etc. and in there original positions.
Disclaimer:
A failure to follow these fitting instructions could cause serious injury,
death or property damage. These hand guards are intended solely for use with
motorcycles/ATV/snowmobiles/scooters that have not been modified. They are not
designed to prevent injury or death while riding or in an accident or crash.
The user must ensure that all controls are free of the handguards every time
that they ride. By installing and/or using this product you knowledge that you
accept these terms and have followed the fitting instructions.
Support
Email: info@barkbusters.net
@BARKBUSTERSHANDGUARDS
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>