Barkbusters YAMAHA MT 07 Aluminum Handguard Kit Instructions
- June 4, 2024
- Barkbusters
Table of Contents
Barkbusters YAMAHA MT 07 Aluminum Handguard Kit
FITTING INSTRUCTIONS for
- YAMAHA MT 07 (‘21 on)
- YAMAHA MT 09 (‘13 – ’20)
- YAMAHA MT 09 SP (‘18 – ’20)
- YAMAHA MT 09 TRACER (‘14 – ’20)
- YAMAHA XSR 900 (‘16 on)
Preparation
MT 07/09 / XSR 900
Remove the original handlebar end weights.
MT 09 TRACER
Remove the original handguard and brackets. Retain M8 Washer from under bar
end bolt.
Fitting Procedure shown for the RIGHT side
(repeat for right side with applicable parts)
- Fit threaded insert (8) and tighten to specified torque setting.(not required for MT 09 TRACER)
- Loosely assemble clamp to handlebar as per diagram.
- Attach backbone with applicable parts as per diagram.
Note: The preferred backbone position is horizontal when viewed from the side. Tighten all bolts in the following order (7), (6), then (4 and 5). Use recommended torque specifications over .
MT 09 TRACER
NOTE
Use original M8 Washer which is located under the head of the original bar end
bolt on each side of the handlebar.
Bar Side View
Email: info@barkbusters.net BARKBUSTERSHANDGUARDS
Instructions
NOTE
Items 8 & 9 are not required for fitting to MT 09 TRACER. Use original M8 washers instead (see diagram over page).
Recommended Torque Settings
- M6 10 Nm (7.4 lbf ft)
- M8 20 Nm (14.8 lbf ft)
- M16 (item 8) 21Nm (15.5 lbf ft)
CAUTION
Installation of the handguard is safety-relevant work and can be complicated.
We recommend the installation be performed by a motorcycle service technician.
Rideworx accepts no liability for damages caused by improper mounting. All
screws, bolts, and nuts, including all replacement hardware provided by
Rideworx, should be tightened to the torque specified in the table. After the
first 50km of riding check all screws, bolts, and nuts are tightened to the
correct torque. We recommend a medium-strength liquid thread lock product on
all fasteners.
WARNING
Check the operation of all handlebar controls, specifically, the throttle,
front brake, kill switch, and clutch to ensure they are operating correctly
and are in accordance with the OEM specifications. Do not ride the motorcycle
if any controls are not operating correctly or if rear view mirror vision is
obscured. Check periodically that all bolts are tight.
Disclaimer
A failure to follow these fitting instructions could cause serious injury, death or property damage. These handguards are intended solely for use with motorcycles/ATV/snowmobiles/scooters that have not been modified. They are not designed to prevent injury or death while riding or in an accident or crash. The user must ensure that all controls are free of handguards every time they ride. By installing and/or using this product you acknowledge that you accept these terms and have followed the fitting instructions. INS-BHG-094-00-NP
Phone: +61 (0)2 4271 8244
Email: info@barkbusters.net
Web: www.barkbusters.net
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>