Barkbusters Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit Owner’s Manual

June 13, 2024
Barkbusters

Barkbusters logo www.barkbusters.net

Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit

Barkbusters Triumph Tiger 660 Sport 2022 On Aluminum Handguard
Kit FITTING INSTRUCTIONS
for…
TRIUMPH T iger 660 Spor t (‘2 0 22 –on)

Preparation

Remove original handguards and bar end weights if fitted. Barkbusters
Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit - parts
1Barkbusters
Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit - parts
2Barkbusters
Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit - parts
3NOTE:
Wiring from left and right side will need to be moved.
Bar End Cap (11) will need to be centralised before tightening.

Installation for Right Side.

Repeat for Left side with applicable parts.

  • Loosely assemble the clamp to the handlebar as per diagram.
  • Attach the handguard backbone (1) with applicable parts to the handlebar end and also to the clamp connector (5).
  • Position backbone so it is horizontal when viewed from the side.
  • Tighten all bolts in the following order: (10), (9), (4) then (7).

Important: Use the specified torque setting over page. Barkbusters
Triumph Tiger 660 Sport 2022 On Aluminum Handguard Kit - parts
4Recommended Torque Settings

M6   10 Nm (7.4 lbf ft)
M8   20 Nm (14.8 lbf ft)

Personalise Your Protection
Guard options sold separately

| JET-003
---|---
| VPS-003
| STM-003
| BCF-003

CAUTION:
Installation of the handguard is safety-relevant work and can be complicated. We recommend the installation be performed by a motorcycle service technician. Rideworx accepts no liability for damages caused by improper mounting. All screws, bolts and nuts, including all replacement hardware provided by Rideworx, should be tightened to the torque specified in the table. After the first 50km of riding check all screws, bolts and nuts are tightened to the correct torque. We recommend a medium strength liquid thread lock product on all fasteners.
WARNING:
It is important there is a working clearance (approx 3mm) between the throttle grip end and the handguard to ensure a free closing throttle. Check operation of all handlebar controls, specifically the throttle, front brake, kill switch and clutch to ensure they are operating correctly and are in accordance with the OEM specifications. Do not ride the motorcycle if any controls are not operating correctly. Check periodically that all bolts are tight.
Disclaimer:
A failure to follow these fitting instructions could cause serious injury, death or property damage. These handguards are intended solely for use with motorcycles/ATV/snowmobiles/scooters that have not been modified. They are not designed to prevent injury or death while riding or in an accident or crash. The user must ensure that all controls are free of the handguards every time that they ride. By installing and/or using this product you acknowledge that you accept these terms and have followed the fitting instructions.

Barkbusters logoBarkbusters Triumph Tiger 660 Sport 2022 On Aluminum
Handguard Kit - logo 5 Email: info@barkbusters.net
BARKBUSTERSHANDGUARDS
INS-BHG-095-00-NP

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals