ATANDT 06724 15W Qi2 Fast Charge Wireless Charger Instructions
- June 27, 2024
- ATandT
Table of Contents
ATANDT 06724 15W Qi2 Fast Charge Wireless Charger
Product Specifications
- Dimensions: 140 mm x 90 mm
- Double-sided printed
- Colors: 299C K100 (Outside), 299C 1797C 368C K100 (Inside)
- Wireless Charger: 15W Qi2 Fast Charge
- Input: 5VDC/3A; 9VDC/2.22A; 12VDC/1.67A
Installation Guidelines
- Ensure the equipment is installed as per the provided instructions to prevent harmful interference.
- If interference occurs, try reorienting or relocating the receiving antenna, increasing separation between equipment and receiver, or using different circuits.
- Consult a professional if needed to correct interference issues.
- For FCC RF exposure compliance, maintain a minimum distance of 20cm between the equipment and your body.
Frequently Asked Questions (FAQ):
Q: What should I do if the wireless charger is not charging my device?
A: Make sure the charger is properly connected to a power source and that your
device is placed correctly on the charging pad. Check for any obstacles
between the charger and your device that may be interfering with the charging
process.
User Manual
15W Qi2 Fast Charge Wireless Charger
CAUTION :
This wireless charger ONLY-rlu on devices that have built-in wireless. Do not
attempt to disassemble the wireless charging pad as it may damage the product.
Specifications
- (charger not included)
- Input:5VDC/3A;9VDC/2.22A;12V
- Output:SW{7.SW/10W/15W
- Charging distance: 5-Gmm
Using your Fast Wireless Charging Pad
- Power up your Wireless Charging Pad using the provided USB-C cable. Use Wall Charger (not provided) based on the specification provided.
- Place your Qi-enabled device on the Wireless Charging Pad with the screen facing up.
WARNING: Any metallic/conductive object between the device and wireless charging pad will cause an ERROR (i.e. metallic plate)
Charging Indicator Light Status
- Red flashing light: ERROR, please re-position your device
- Green light: CHARGING, lights up green flashes 3 times and goes off (device will remain to charge)
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.