Beat-Sonic BSA63 Smartphone Holder Instruction Manual

Table of Contents

Beat-Sonic-BSA63-Smartphone-Holder-PRODUCT

Thank you for purchasing the Beat-Sonic BSA63 Mobile Device Holder.
Designed and made in Japan, this product represents our commitment to quality and excellence.
Please read this manual carefully before installing this product to ensure correct operation.

Designed specifically for ZN8 Toyota GR86 & ZD8 Subaru BRZ
Secure mounting position does not obstruct visibility or block air vents
“L-Bracket” provides the option to attach a variety of Beat-Sonic mobile device holders
Wireless charging holder automatically charges all Qi-enabled mobile devices

Beat-Sonic-BSA63-Smartphone-Holder-FIG-1

Adjust the stand so that the mobile device does not interfere with the operation of the gear shift lever.
Extreme changes in temperature and harsh vibrations may cause the joints of the stand to work loose. Periodically check the stand and holder are correctly secured and tightened as necessary.
Beat-Sonic and its affiliates shall not be held responsible for any consequence, either directly or indirectly, as a result of installing and/or using this product.

Step 1. Apply anti-scratch protective film

Parallel to the edge of the passenger side gear shift surround trim, measure 14cm (5.5 in.) from the panel seam where the shift surround panel meets the center console box. Mark the location with masking tape.
On the lower section of the passenger side center console side panel, measure 9.5cm (3.74 in.) from the seam where the center console side panel joins the center console box. Apply another piece of masking tape to mark the location.
Apply the clear protective film strips to the plastic trim forward of the masking tape position markers as shown in the above illustration, then remove the masking tape markers.

Step 2. Attach the paper template

Cut out the supplied paper template. Align the back edge of the template with the seam where the center console side panel joins the center console box. Use masking tape to temporarily hold it in place.
Remove the double-sided tape backing film from the stand. Using the template as a guide, (a) clip the lower edge of the stand under the center console side panel then (b) clip the upper section of the stand over the gear shift surround trim.
Apply medium pressure to the side of the stand for at least 20 seconds to ensure strong adhesion of the double-sided tape. In cold weather use a hair dryer to warm the mating surfaces.

Step 3. Attach the holder

Complete the installation by attaching the mobile device holder to the stand.
If the holder does not fit tightly to the L-Bracket, apply 1 ~ 2 pieces as required of the supplied packing stickers to the back of the holder. The stickers act as shims to remove any play.

Wireless Charging Holder Components
Initial set-up
- Press the arm release button to extend the arms
- Mount the phone and close the arms with just enough pressure to firmly hold the phone. Squeezing arms together too tightly will make the phone difficult to remove and insert.
After the initial set-up, the phone can be inserted by sliding into one side of the holder’s arms and then clipping the phone into place. Remove by pulling one side of the phone to release the holder’s arm.

Beat-Sonic-BSA63-Smartphone-Holder-FIG-12

Beat-Sonic-BSA63-Smartphone-Holder-FIG-13

This product uses the Qi wireless charging standard as defined by the Wireless Power Consortium.

Use the supplied USB cable for the best performance. Using a different cable can result in longer charging times and reduced charging performance.
High-speed charging requires a QC2.0 / QC3.0 USB charging outlet.
Place the centre of the phone on the centre of the charging coil for best charging performance.
High ambient temperature can affect charging speed and may cause charger to temporarily stop charging.
Phone cases with metallic inserts will prevent wireless charging.
Do not place credit cards, magnetic stripe cards, key cards, etc. near the charging coil.

Beat-Sonic-BSA63-Smartphone-Holder-FIG-14