SHANGHAI 2048596-00-A Wireless Portable Charger User Manual
- June 26, 2024
- SHANGHAI
Table of Contents
SHANGHAI 2048596-00-A Wireless Portable Charger
Product Information
Specifications
- Compliance: Part 15 of FCC Rules
- RF Exposure: General requirement met
Product Usage Instructions
Caution
Any changes or modifications to this device not explicitly approved by the
manufacturer could void your authority to operate this equipment.
Compliance
Operation of this device is subject to the following conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure
The device has been evaluated to meet general RF exposure requirements.
Frequently Asked Questions (FAQ)
-
Q: Can I modify the device on my own?
A: No, any changes or modifications not approved by the manufacturer may void your authority to operate the equipment. -
Q: What are the operation conditions for the device?
A: The device should not cause harmful interference and must accept any received interference. -
Q: Is the device compliant with FCC regulations?
A: Yes, the device complies with Part 15 of the FCC Rules.
Quick Start Guide
Wireless Portable Charger
Check the remaining battery level
Charging your portable charger
Charging your devices
Charge and recharge simultaneously
Specifications
- Part Number: 2048596-00-A/2058793-00-A/2058795-00-A/2062796-00-A/ 2062797-00-А/2062798-00-А
- Capacity: 5000mAh/19.25WH Input: 5V/2.4A, 9V/2A, 12V/1.5A
- Output: 5V/2.4A, 9V/2.22A, 12V/1.67A
- Wireless Output(Primary): 15W(Max)
- Wireless Output(Secondary): 5W(Max)
- Wireless Receiver(RX): 10W(Max)
- Simultaneous Output: 5V/3A(Two Ports Max)
CAUTION
- Do not disassemble or modify
- Avoid leaving the charger in the car during hot seasons.
Tesla (Shanghai) Co.,Ltd. Made in China
Q: Is the product safe when it gets warm/hot?
A: Wireless charging may cause slight warming during intensive use. The
product uses metal materials for better heat dissipation, resulting in faster
charging. It complies with international safety standards (EN 62368-1 and IEC
62368-1) for safe usage.
Q: Can a phone case affect wireless charging?
A: For optimal wireless charging, use Apple’s official magnetic phone cases.
Avoid cases thicker than 2.5 mm and non-magnetic cases, as they may reduce
charging efficiency.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>