Shanghai Longqian Toys JR1602FCC Remote Control User Manual
- June 4, 2024
- Shanghai Longqian Toys
Table of Contents
Longqian Toys JR1602FCC Remote Control
User Manual
JR1602FCC Remote Control
- Supply Voltage—DC 3.0V , Battery 2*1.5V AAA (not included)
- Frequency 2.407GHz-2.473GHz
- Instructions
a.
First-time use needs to match code, this product has a memory function
c. Turn on the car body power now, The first LED lit up, Matching code Success e. Keys caption：“△ ” Forward, “ P ” Brake.
d. Remoter 10 seconds not run will be standby, Press any key wake up “ ” Back,“ ” Left,“ ” Right, “ S ”Speed, Press “ S ” key set up speed, 1 led lit up is a low speed，2 leds lit up is a medium speed, 3 leds lit up is a high speed, Back a car is an only low speed
△
△ △
Press the “ P ” key to hold the brake, All LED flicker
Replace battery is unnecessary to match the code
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
※ The remote controller only can be used with an adult’s guidance
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
b. Hold down the “▲ ” & “ ” keys for 3 seconds to start the match the code,
The first LED flicker ▲
Warning: Changes or modifications to this unit are not expressly approved
by the part responsible for compliance and could void the user’s authority to
operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>