GERMAN POOL TOR-721 Wall Mount Range Hood Instruction Manual

June 26, 2024
GERMAN POOL

Wall-Mount Range Hood
TOR -721
TOR -723
TYP -716
TYP -717

TOR-721 Wall Mount Range Hood

Please read these instructions and warranty information carefully before use and keep them handy for future reference.
Notice Before Use
Important
For safety purpose, you should read the instructions carefully before using the appliance for the first time.
Save the instructions for future reference.
The appliance is designed for domestic use and may only be installed and operated in accordance with these instructions for use.

  1. The appliance is not intended for the use of, and playing with, by persons (including children) with reduced physical, sensory or mental capabilities, or any individual lacking experience and knowledge, unless they have been given supervision or instruction.
  2. Keep children away from the appliance. Do not let them use the appliance without supervision.
  3. If the power supply cord is damaged, do not operate the appliance. Contact German Pool or a licensed technician for replacement immediately.
  4. Disconnect the power supply before cleaning,
  5. The range hood must be earthed.
  6. Connect the range hood with an independent air vent for exhausting fumes to the exterior.
  7. The connection opening at the top of the range hood is to be connected to the exhaust pipe for exhausting fumes into the air vent. Exhaust pipe of 6 inches in diameter should be used.
  8. To protect electrical parts, do not splash or spray the range hood with water.
  9. The appliance should be positioned 700±50mm above the cooking range.
  10. Do not flambe under the range hood.
  11. German Pool range hood has high venting efficiency. Most of the grease vapor will be exhausted through the air vent when the range hood is in operation. Hence only very little amount of residual oil will be collected in the oil container.
  12. The air must not be discharged into a venting pipe that is used for exhausting fumes from appliances burning gas or other fuels.
  13. There should be adequate ventilation of the room when the range hood is used along with appliances that burn gas or other fuels.
  14. Regulations concerning the discharge of air have to be fulfilled.
  15. To prevent fire hazard in case of oil build-up, the turbine impellers and other easily-soiled parts must be cleaned at least once a week.
  16. Please wear safety gloves for installation, cleaning, light bulb changing and dismantling in order to prevent injuries.

Attention
This symbol indicates that this product should not be disposed with other household wastes throughout the E.U. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer from where the product was purchased. They can take this product for environmentally safe recycling.

Product Structure

  1. Control Panel

  2. Bottom Cover Knob (1 pair)

  3. Bottom Cover

  4. Oil Container (1 pair)

  5. Fan Grille (1 pair)

  6. Lighting

  7. Oil Collector (1 pair)

  8. Left Fan On/Off Switch

  9. Left Speed Control Super Normal

  10. Right Fan On/Off Switch

  11. Right Speed Control Super  Normal

  12. Light Switch

  13. Control Panel

  14.  Bottom Cover Knob (1 pair)

  15. Bottom Cover

  16. Oil Container (1 pair)

  17. Fan Grille (1 pair)

  18. Lighting

  19. Oil Collector (1 pair)

  20.  Left Speed Control

  21.  Right Speed Control Super  Normal Super  Normal

  22. Main Power Switch

  23.  Light Switch

Installation Instructions

I. Height of Installation
The appliance should be positioned 70-75 cm above the cooking range. A distance that is near 70 cm results in higher venting efficiency.
II. Installation Procedures

  1. Drill holes in the wall based on the positions and distance between the mounting brackets.
  2. Install screw anchors in the holes. Screw the mounting brackets through the anchors. Secure screws with nuts.
  3. Loosen the screws of the mounting stand at the back of the range hood. Adjust the range hood to a suitable position on the wall.
  4. Keep the range hood horizontally balanced and fix it to the wall with screws provided. Place the provided rubber cap behind the range hood so that the front of the unit is tilted slightly (Fig. 1).

 Care & Maintenance

Important

  • To ensure the most optimum efficiency, the range hood must be cleaned at least once a week.
  •  Warning: There is a risk of fire if repair and cleaning of the range hood (especially the fan and other easily-soiled parts) are not carried out in accordance with the instructions.
  1. Cut off the power supply before cleaning the range hood.
  2. Remove the two oil containers, then turn the 2 bottom cover knobs to detach the bottom cover.
  3. Detach the oil collecting trays. For TOR-723 or TYP-717 models, free oil collecting trays from the two small buckles (Fig 3).
  4. Loosen the locking caps by turning the caps clockwise and take out the turbine impellers.
  5. Use a soft cloth to clean the inner and outer surfaces with a mild liquid detergent, and then rinse the trays with water. Avoid using a rough or metal brush to scrub the surface.
  6. After cleaning, assemble the parts in reverse order as shown above. To ensure safety, make sure that the bottom cover is securely hooked with the hood body.

**Technical Specifications

**

Model TOR-721 TOR-723 TYP-716 TYP-717
Voltage / Frequency 220 V/ 50 Hz
Rated Power 310 W 160 W
Colour Silver
Motor Speed 2,100 R.P.M. 2,300 R.P.M. 1,600 R.P.M. 1,650 R.P.M.
Exhaust Flow 1,320 m3/hr 1,380 m3/hr 960 m3/hr 1,020 m3/hr
Lighting 40 W
Exhaust Outlet Diameter 0152mm / 6″
Dimensions (H) 100 mm (W) 711 mm (D) 530 mm (H) 140 mm (W) 711 mm (D) 523
mm (H) 100 mm (W) 711 mm (D) 530 mm (H) 140 mm (W) 711 mm (D) 523 mm
Net Weight 10.5 kg 11.3 kg 10.2 kg 11.1 kg

Specifications are subject to change without prior notice.
If there is any inconsistency or ambiguity between the English version and the Chinese version, the Chinese version shall prevail.
Refer to www.germanpool.com for the most up-to- date version of the Operating Instructions.
For additional product information, please visit our website. www.germanpool.com
Please fill out the form below. This information and the original purchase invoice will be required for any repairs.
Warranty will be invalid if information provided is found to be inaccurate or purchase invoice is not presented.
Model No.:  TOR-721  TOR-723 CLITYP-716   TYP-717
Serial No.:……..
Purchased From :………….
Invoice No. :…………..
Purchase Date :…………
Warranty Terms & Conditions
Under normal operations, the range hood will receive a 1-year full warranty provided by German Pool. Motor warranties for TOR-721 and TOR-723 models are 10 years, and for TYP-716 and TYP-717 models 3 years. (Effective starting from the date of purchase.)

  1. Customer who fails to present original purchase nvoice will be disqualified for free warranty.

  2. Customer should always follow the operating nstructions. This warranty does not apply to: – labour costs for installation, on-site check-up, replacement of parts and other transportation costs;
    – damages caused by accidents of any kind (including transport and others);
    – casing of hood body, ight bulbs, plastic parts and accessories such as oil collecting cups;
    – operating failures resulted by incorrect voltage, mproper operations and unauthorized installations or repairs.

  3. This warranty is invalid f:
    – purchase nvoice s modified by unauthorized party;
    – product is used for any commercial or industrial applications;
    – product is repaired or modified by unauthorized personnel, or unauthorized parts are installed;
    – serial number is modified, damaged or removed from the product

  4. German Pool will, in its discretion, repair or replace any defective part.

  5. This warranty will be void if there s any transfer of ownership from the original purchaser.

  • Service area ncludes Hong Kong Island, Kowloon and New Territories only. Repairs in Tung Chung, Discovery Bay or other areas are subject to an extra service charge.

Customer Service & Repair Centre
German Pool (Hong Kong) Limited 8/F, China Travel (Cargo) Logistics Ce
1 Cheong Tung Road
Hung Hom, Kowloon, Hong Kong
Tel : +852 2333 6249
Fax : +852 2356 9798
Email : repairs@germanpool.com
German Pool( Hong Kong) Limited

Hong Kong, China
Room 113, Newport Centre Phase II,
116 Ma Tau Kok Road, Tokwawan,
Kowloon, Hong Kong
Mainland China
3/F, Takshun Plaza, Nanguo East
Road, Shunde, Foshan, Guangdong
Tel: +86 757 2980 8308
Fax: +86 757 2980 8318
Macau, China
Alameda Dr. Carlos D’Assumpcao
No. 263, Edif. China Civil Plaza, 15
Andar, I, Macau
Tel: +853 2875 2699
Fax: +853 2875 2661 •
© All rights reserved. Copying, reproducing or using the contents of this manual is not allowed without prior authorization from German Pool, violators will be prosecuted.

www.germanpoool.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

GERMAN POOL User Manuals

Related Manuals